Frigidaire FFID2426TW Complete Owners Guide - Page 14

Normal Sounds You Will Hear

Page 14 highlights

BEFORE YOU CALL Vapor at Vent • Spilled rinse aid can cause foam and lead to overflowing. Wipe up any spills with a damp cloth. Dishware Stained or Discolored • Tea and coffee can stain cups. Remove the stains by hand washing in a solution of 1/2 cup (120 ml) bleach and one quart (1L) of warm water. Rinse thoroughly. • Iron deposits in water can cause a yellow or brown film. A special filter installed in the water supply line will correct this problem. (See Removing Spots and Film). • Aluminum utensils can leave gray/ black marks when they rub against other items. Load Properly. • Certain high acid foods can cause discoloration of stainless steel and plastics if allowed to sit for a long period. Use the Rinse Only cycle or rinse by hand if not operating dishwasher at once. • Mixing stainless steel and silver utensils in silverware basket can cause pitting of the stainless steel blades. Avoid mixing stainless steel and silver. Water in Bottom of Tub • Water left in the tub bottom after the cycle is complete is not normal. If water remains in the bottom of the tub, the dishwasher may not be draining properly. (See Dishwasher Does not Drain Properly). Cycle Takes a Long Time • The cycle may have been automatically lengthened to reach key temperatures due to some factor such as a cool water supply or a large load of dishes. • Delay Start option may have been selected. • Choose lower temperature options to shorten the cycle. • Cycles that are soil-sensing adjust automatically to assure a good wash - heavier soils will elicit a longer cycle response. 14 Etching • Using too much detergent especially in soft or softened water causes damage that looks like a film but cannot be removed. • Adjust the amount of detergent based on the water hardness. (Check Detergent Chart). • Lower the water temperature by selecting one of the lower temperature options. Detergent Left in Cups • Detergent may be old. Discard and use fresh detergent. • Be sure the dish load doesn't block spray from entering the detergent cup. • Check to see if cycle has been completed. • Make sure items do not prevent the detergent dispenser from opening. Dishwasher Leaks • Check that the door gasket is pressed into its mounting channel, reaches to the bottom of the tub and does not extend beyond the end rib so as to interfere with door closure. • Spilled rinse aide can cause foam and lead to overflowing. Wipe up any spills with a damp cloth. • Check to see that the dishwasher is level. (See Installation Instructions). • Avoid oversudsing by using the correct amount of detergent designed for automatic dishwashers. • Check to see that dishwasher is level. (See Installation Instructions). Normal Sounds You Will Hear • Normal sounds include water fill, water spray, draining and motor sounds. • There is a noticeable change in sound when the wash action switches between the lower and middle spray arm. This is normal since each spray arm has its own sound. • It is normal for the dishwasher to pause (no sound) when the wash action is switching between the lower and middle spray arms.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

14
BEFORE YOU CALL
Dishware Stained or Discolored
Tea and coffee can stain cups.
Remove the stains by hand washing in
a solution of 1/2 cup (120 ml) bleach
and one quart (1L) of warm water.
Rinse thoroughly.
Iron deposits in water can cause a
yellow or brown film.
A special filter
installed in the water supply line will
correct this problem. (See Removing
Spots and Film).
Aluminum utensils can leave gray/
black marks when they rub against
other items.
Load Properly.
Certain high acid foods can cause
discoloration of stainless steel and
plastics if allowed to sit for a long
period.
Use the Rinse Only cycle
or rinse by hand if not operating
dishwasher at once.
Mixing stainless steel and silver
utensils in silverware basket can cause
pitting of the stainless steel blades.
Avoid mixing stainless steel and silver.
Etching
Using too much detergent especially
in soft or softened water causes
damage that looks like a film but
cannot be removed.
Adjust the amount of detergent
based on the water hardness. (Check
Detergent Chart).
Lower the water temperature
by selecting one of the lower
temperature options.
Detergent Left in Cups
Detergent may be old.
Discard and
use fresh detergent.
Be sure the dish load doesn’t block
spray from entering the detergent
cup.
Check to see if cycle has been
completed.
Make sure items do not prevent the
detergent dispenser from opening.
Dishwasher Leaks
Check that the door gasket is pressed
into its mounting channel, reaches to
the bottom of the tub and does not
extend beyond the end rib so as to
interfere with door closure.
Spilled rinse aide can cause foam and
lead to overflowing.
Wipe up any
spills with a damp cloth.
Check to see that the dishwasher is
level.
(See Installation Instructions).
Avoid oversudsing by using the
correct amount of detergent designed
for automatic dishwashers.
Check to see that dishwasher is level.
(See Installation Instructions).
Water in Bottom of Tub
Water left in the tub bottom after
the cycle is complete is not normal.
If water remains in the bottom of
the tub, the dishwasher may not be
draining properly. (See Dishwasher
Does not Drain Properly).
Cycle Takes a Long Time
The cycle may have been automatically
lengthened to reach key temperatures
due to some factor such as a cool water
supply or a large load of dishes.
Delay Start option may have been
selected.
Choose lower temperature options to
shorten the cycle.
Cycles that are soil-sensing adjust
automatically to assure a good wash
- heavier soils will elicit a longer cycle
response.
Vapor at Vent
Spilled rinse aid can cause foam and
lead to overflowing.
Wipe up any spills
with a damp cloth.
Normal Sounds You Will Hear
Normal sounds include water fill,
water spray, draining and motor
sounds.
There is a noticeable change in
sound when the wash action switches
between the lower and middle spray
arm.
This is normal since each spray
arm has its own sound.
It is normal for the dishwasher to
pause (no sound) when the wash
action is switching between the lower
and middle spray arms.