Frigidaire FGAC5045W1 Complete Owners Guide - Page 14

14 OPERATING INSTRUCTIONS Situation When bucket full or clean filter light is on. When E4, EC, AS or ES error occur. When unit is connecting to internet. Quick Glance Light Behavior The light will emit orange light and gradually turn dark and bright every 4 sec. The light will emit red light and gradually turn dark and bright every 4 sec. The light will flash white light. • When the unit is establishing connection to internet the quick glance light will flash in white light and if the connection is established the quick glance light will emit white light for 10 sec then follow the behavior in above table. • The light can be activated or deactivated by pressing and holding the "Fan Speed" button and "+" button simultaneously for 3 sec. 2. To turn the unit on, press the ON/OFF button. The unit will run in the factory setting of Auto mode. In this mode, the unit will automatically set a comfortable humidity and fan speed according to the indoor environment. Note: In this mode, set humidity and fan speed can not be changed manually and the display will show actual room humidity. NOTE Unit must be upright for one hour prior to operating. 1. Plug the power cord into a properly grounded 115 volt AC outlet. NOTE If the "BUCKET FULL" light is flashing, remove the bucket and re-install to reset the float switch. 3. To use Quiet mode, press the Mode button to choos Quiet mode. The unit will run in low fan speed for the whole time and the unit will automatically set a comfortable humidity according to the indoor environment. Note: In this mode, set humidity and fan speed can not be change manually and the display will show actual room humidity.