Frigidaire FGAC5045W1 Complete Owners Guide - Page 16
Fault Codes, Removing Collected Water
View all Frigidaire FGAC5045W1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
16 OPERATING INSTRUCTIONS 9. Press and hold the " - " and " + " for 3 sec can activate or deactvate the LOCK function. The display will show LC for 5 secs. The control panel will be lock and the setting can not be changed. 2. If the display reads "EC" , check the following operating conditions. Outlet voltage should be 115V±10% and the surrounding temperature should be with in the range of 41 °F to 89 °F. Unplug the unit and plug it in again under normal operating conditions. If the "EC" code persists, contact your Authorized Frigidaire® Service Center. 10. The unit is equipped with a device called an ionizer. This device can only be activated and deactivated via the Frigidaire® App, which can be downloaded onto your smart phone device. When the ionizer is activated, it will help to reduce airborne pollutants and clean your room's air faster. 3. If the display reads "E4", the communication between display PCB and main control PCB is faulty. Contact your Authorized Frigidaire® Service Center. 11. To shut the unit down, press the ON/OFF button. Removing Collected Water Note: After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored. Fault Codes 1. If the display reads "AS" or "ES" , a sensor has failed. Contact your Authorized Frigidaire® Service Center. 1. Emptying the Bucket: a. When the bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate. b. Do not move the unit at this time otherwise water may spill on the floor. c. Press sides of bucket gently to unclip the bucket from the unit. d. Remove the bucket as shown in the photographs below and empty the bucket.