Frigidaire FGHB2844LF Complete Owner's Guide (English) - Page 6
INSTALLATION, Leveling Freezer Drawer, Level Refrigerator & Adjust Doors
UPC - 012505698040
View all Frigidaire FGHB2844LF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation Leveling Freezer Drawer (if necessary) NOTE DO NOT remove center screw from freezer drawer. This is a factory adjustment. To level the freezer drawer: 1 Check gasket seal around top, bottom, and sides of freezer drawer. 2 If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2) on each side) to allow drawer to rotate. Most of these conditions can be met by raising or lowering the adjustable front rollers. To level the cabinet using the front rollers: 1 Slightly open freezer drawer. Lift the toe grille and gently pull forward (see illustration). 3 Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer. 2 You can raise or lower each door. use a 3/8 inch socket wrench to turn the adjustment screws (1 per side). To raise: turn adjustment screw clockwise. To lower: turn adjustment screw counterclockwise. 3 Ensure both doors are bind-free with their seals touching the cabinet on all four sides and that cabinet is stable. 4 After unit is leveled, lower anti-tip leg until it contacts the floor. Push Against Freezer Drawer Grab Drawer At Center From Both Sides Then Pull Drawer Out A B 4 Tighten four (4) drawer screws. 5 Recheck gasket seal. 6 Install the toe grille by fitting into place. Level Refrigerator & Adjust Doors (if necessary) Guidelines for final positioning of your refrigerator: • All four corners of the cabinet must rest firmly on the floor. • The sides should tilt 1/4 inch (6 mm) from front to back (to ensure that doors close and seal properly). • Doors should align with each other and be level. 6 Door Door Anti-tip Leg Raise Lower