Frigidaire FPID2495QF Complete Owner's Guide - Page 19
Removing Spots and Film
View all Frigidaire FPID2495QF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
BEFORE YOU CALL Vapor at Vent Stains on Tub Interior • Spilled rinse aid can cause foam and lead to • overflowing. Wipe up any spills with a damp cloth. • Check to see that dishwasher is level. (See Installation Instructions). Dishwasher Won't Run Washing large amounts of dishware with tomato based soil can cause a pink/orange appearance. This will not affect performance and will gradually fade over time. Pre-rinsing or using the Rinse Only cycle will reduce the chance of staining. Using air dry option will lessen staining. • Check to see if circuit breaker is tripped or if a fuse is blown. • Make sure water supply is turned on. • Check to see if cycle is set correctly. (See Operating Instructions). • Is dishwasher set for Delay Start Option? • Make sure door is closed and latched. Dishwasher Won't Fill • Is water supply turned on? Dishwasher Does Not Drain Properly Removing Spots and Film Hard water can cause lime deposit buildup on the interior of the dishwasher. Dishes and glasses may also get spots and film for a number of reasons. (See Glassware/Flatware Spotted or Cloudy section). To remove buildup, and film, clean using the following instructions: 1. Load clean dishes and glasses in normal manner. Do not load any metal utensils or silverware. • If unit is hooked up to a food waste disposer, 2. make sure the disposer is empty. 3. • Check to see if the knockout plug has been removed from inside the food waste disposer inlet. • Check to see if drain hose is kinked. 4. • Make sure cycle is complete, not in a pause. Dishwasher has an Odor 5. • Soiled dishes left in dishwasher too long can create an odor. Use Rinse Only cycle. 6. Do not add detergent. Select the NORMAL WASH cycle. Press START/CANCEL pad. Close and latch the door. Allow dishwasher to run until it starts the second water fill (approximately 10 minutes). Unlatch an and open door and pour 2 cups of white vinegar into the bottom of dishwasher. Close and latch door and allow cycle to finish. • There will be a "new" smell when first installed. This is normal. • Check to see if unit is draining properly. (See Dishwasher Does Not Drain Properly). 19