Fujitsu FI 5015C Operator's Guide - Page 26

2.2 Loading Documents on ADF This section explains how to check the document condition and load them on ADF. These operations are very important to avoid paper jam or scanning error. 2.2.1 Checking document condition Check that the document meets the following condition. • If the documents do not meet the conditions, scan them on Flatbed HINT referring to "Loading Document on Flatbed" on page.16 • If you scan sheets of paper that is not recommended for feeding with ADF, a paper jam may occur in the scanner or a wrinkle may occur on a sheet. To prevent this from occurring, use Flatbed when scanning such paper. ■ Document Size For ADF: Minimum 115 (Width) x 140 (Length) mm (4.53 x 5.51 in.) Maximum 216 (Width) x 355 (Length) mm (8.5 x 14 in.) ■ Document Type The following paper types are recommended for ADF scanning: • Woodfree paper • Wood containing paper When using documents other than above paper types, scan som test sheets of the same type to see if the documents can be scanned or not, before attempting to scan the documents. ■ Document Thickness Paper thickness is generally expressed by "paper weight". The following shows the paper weights that can be used on this scanner: • 52 g/m2 to 127 g/m2 (14lb to 34lb) ■ Precautions The following documents may not be scanned successfully: • Documents of non-uniform thickness (e.g. envelopes) • Wrinkled or curled documents (Refer to HINTs on the next page) • Folded or torn documents • Tracing paper • Coated paper • Carbon paper • Carbonless paper • Photosensitive paper • Perforated or punched documents 12