Fujitsu ST5111 User Guide - Page 37

Osian_UG.book Page 25 Monday, October 9, 2006 1:24 PM Using Your Stylistic ST5100 The Stylistic ST5100 pen is a sophisticated, high-quality electronic instrument that can be damaged if used improperly. Treat the pen as you would any precision device. The following list contains guidelines for proper pen handling: • Do not gesture with the pen, use it as a pointer, or tap it on surfaces other than the Tablet PC screen. • Do not try to turn the thumb grip on the pen; it is designed for inserting and removing the pen from the pen holder and for attaching a pen tether. • Never store the pen with the tip bearing the weight of the pen (e.g., sitting tip down in a pencil cup). Storing the pen tip down could distort the internal mechanism over a period of time (especially in higher temperatures), causing the tip to act as if it is always depressed. To avoid damage, the pen should be stored in the pen holder when not in use. The screen reacts when the pen tip is approximately 1/8 inch (3-5 mm) from the screen. The pen has four switches: a tip switch, a barrel button toggle switch with switches at both ends, and an "eraser" switch, located on the end of the barrel. By default, the tip switch corresponds to the left mouse button, and the front toggle (closest to the pen tip) barrel button switch corresponds to the right mouse button (when used in combination with the tip switch). The rear toggle of the barrel button switch and the eraser switch at the end of the barrel act as electronic ink "erasers". The rear toggle, eraser, and tip click pressures can be changed by clicking [Start] -> Control Panel, and double-clicking the Fujitsu Pen Settings icon. Note that the rear toggle switch and the eraser switch are both affected by the same settings; they cannot be changed individually. To change the rear toggle and eraser button function, select the drop-down list to select a new function, then click [Apply]. If you don't want the rear toggle and button switch to have any function, select Ignore from the list. Adjusting the click pressure determines how much pressure must be put on the pen tip in order for the screen to react. The softer it is set, less pressure is required; the harder it is set, more pressure is required. To change the click pressure, use the slider bar to make the click pressure harder or softer, then click [Apply]. • Ensure that a screen protector is installed on the Tablet PC screen before you use the pen. The warranty does not cover a scratched screen. • Use only the pen provided with your Tablet PC. Do not use substitutes that were not designed for the Stylistic ST5100 Series Tablet PC. Here are some hints that may help you use the pen more effectively: • To activate the tip switch, tap or hold the pen tip against the screen. • To activate the barrel button switch, press and hold the end of the button you wish to use (front toggle is the right mouse button switch; the rear toggle acts as an electronic "eraser"). • To move the cursor, hold the pen tip within 1/8 inch (3 - 5mm) from the screen and move the pen. • To start a program, double-tap the pen tip (tap the pen tip twice rapidly) on the program icon as you would double-click a mouse. • To select an object, tap the pen tip on the object once. • To "double-click" an object, tap twice on the object quickly. • To move, or "drag", an object on the screen, place the pen tip directly over the object, then as you hold the pen tip against the screen, move the pen. CALIBRATING THE PEN For information about calibrating your pen, refer to the literature that came with the operating system. INSTALLING A PEN TETHER To prevent dropping or losing your pen, you should attach it to your system using the pen tether that is included with the system. To attach the pen tether to your Tablet PC, perform the following steps: 1. Attach the end of the pen tether with the smaller loop to your pen. Do do so, push the end of the tether through the hole in the pen, then thread the opposite end of the tether through the loop. (See Figure 2-2.) 25