Garmin Varia UT800 Smart Headlight Owners Manual - Page 7

Customizing Headlight Settings with Your Edge 820 Before you can customize Varia device settings with your Edge device, you must pair the devices (Pairing Your Bike Light with Your Edge 820, page 2). 1 Select > Settings > Sensors > Lights. 2 Select an option: • Select Enable to enable the light network. • Select Network Options > Light Mode to set the light intensity mode for all lights in your network (Light Mode Settings, page 3). • Select Network Options > Light Beam Activated to turn on the headlight automatically when the timer starts or when the Edge device turns on. • Select Network Options > Test Lights to check that each light in your network is set up correctly (Testing the Light Network, page 3). • Select Network Options > Auto Beam Adjustment to adjust the headlight intensity automatically based on the rate of speed. A high intensity is used at high speeds, and a low intensity is used at low speeds. • Select a light to view device information and customize each light in your network (Light Network Settings, page 3). Light Mode Settings From your Edge device, select > Settings > Sensors > Lights > Network Options > Light Mode. Auto: Automatically adjusts the light intensity and light mode based on the ambient light and time of day. This mode is recommended for commuting or road rides. High Visibility: Sets the light intensity to flash mode or the brightest setting available. Trail: Automatically adjusts the light intensity and light mode based on the ambient light and time of day. This mode is recommended for mountain biking. Individual: Allows you to customize the light intensity and pattern mode for each light in your network (Light Network Settings, page 3). Light Network Settings From your Edge device, select > Settings > Sensors > Lights, and select a paired light. Enable: Turns on the light and allows you to control the light remotely with your Edge device. You can disable a light to disconnect it from the light network. Light Mode: Sets the light intensity and pattern mode, or turns off the light. NOTE: This setting is available when you select the Individual light mode setting (Light Mode Settings, page 3). Software Update: Checks for headlight software updates. About: Displays device, software, and battery information. Remove: Allows you to delete a paired light from the network. Testing the Light Network 1 From your Edge device, select > Settings > Sensors > Lights > Network Options > Test Lights. 2 Select a light to test. The light blinks when it is connected. Automatic Beam Intensity When paired with a compatible Edge device, the headlight can adjust automatically based on the current lighting conditions, sunrise and sunset information, and speed. As your speed increases, the headlight shines brighter. At lower speeds, the light intensity is reduced to maximize battery life. Device Information Specifications Battery type Battery life Operating temperature range Charging temperature range Radio frequency/ protocol Rechargeable, built-in lithium-ion battery Up to 1 yr. in standby mode See Headlight Light Intensity Modes and Battery Life, page 3 From -15° to 50°C (from 5° to 122°F) From 0º to 45ºC (from 32º to 113ºF) 2.4 GHz ANT+ wireless communications protocol Device Information Water rating LED luminous flux IEC 60529 IPX7* 100 to 800 lm *The device withstands incidental exposure to water of up to 1 m for up to 30 min. For more information, go to www.garmin.com /waterrating. Headlight Light Intensity Modes and Battery Life Intensity Mode High Medium Low LED Luminous Flux 800 lm 400 lm 200 lm Battery Life Up to 1.5 hr. Up to 3 hr. Up to 6 hr. 3