Garmin Zumo 660 Installation Instructions - Page 1
Garmin Zumo 660 Manual
UPC - 753759085087
View all Garmin Zumo 660 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
zūmo 660 Installation Instructions Mount Your zūmo on the Motorcyle Warning: Incorrectly wiring the power cable with bare wire leads can result in damage to the vehicle or the battery and can cause bodily injury. Garmin strongly recommends having an experienced installer with the proper knowledge of electrical systems install the unit. See the Important Safety and Product Information guide in the product box for product warnings and other important information. Step 1: Connect Power to the Mount Select a suitable and secure location to mount the zūmo on your motorcycle, based on available power sources and safe cable routing. Cradle Headphone/audio out jack (3.5 mm) Bare wires with inline fuse for power connection Power cable Microphone jack (2.5 mm) Mini-USB connector (for traffic receiever) Step 2: Install the Handlebar Base The zūmo includes parts for two handlebar installation solutions. Custom mounts can require additional hardware (www.ram-mount.com). A) To install the U-bolt and handlebar base: 1. Place the U-bolt around the handlebar, and thread the ends through the handlebar base. 2. Tighten the nuts to secure the base. Do not overtighten. Note: The recommended torque is 50 lbf-in. Do not exceed torque of 80 lbf-in. Handlebar base U-bolt Handlebar