GE DCVH680GJMV Use and Care Manual - Page 13

Safety Instructions Operating Instructions Reversing the door swing. STEP-BY-STEP INSTRUCTIONS (cont.) Remove Door Assembly 2. Open the door to approximately 90 degrees. Remove the 4 screws starting from the bottom to the top. Make sure the door is supported while removing the screws. Remove the four screws 3. Loosen the top screw as shown. Unhook the door by lifting and pulling as shown by the arrows. 4. Lay the door down on a soft protected flat surface so that the inner part faces upward (door resting on the handle side). 2 #8 Machine Screws 6 #10 Large Screws 5. Remove the 6 large tapping screws (#10) located around the perimeter of the door outlining the gasket, and the 2 machine screws (#8) on the hinge side. 2 #8 Machine Screws 6. With the screws removed, turn the door over and separate the silver cover part of the door from the door frame and set aside. 7. Unlock the 4 tabs on the plastic cover and separate the plastic cover from the frame. NOTE: Disregard the "DO NOT REMOVE" label on the plastic cover. Troubleshooting Tips Consumer Support 13