GE DCVH680GJMV Use and Care Manual - Page 16

Safety Instructions STEP-BY-STEP INSTRUCTIONS (cont.) GEAppliances.com Reassemble Door Assembly (cont.) 19. After reversing door, there will be a mismatch between the outer door and the inner door. Make sure that the handle part of the outer door is opposite the hinge, as shown. 20. Turn the door over and fasten the outer door to the inner door using the 6 large tapping screws (#10). Operating Instructions Troubleshooting Tips Partially Inserted Screw Tighten All Screws 16 Move Strike Bracket 21. Using a putty knife or any other flat tool, remove the 5 plastic screw caps located on the dryer where the door will be installed and install them on the opposite side. 22. Switch the strike bracket and its cover on the opposite side by removing the screws; then reinstall both on the opposite side. Reinstall Door Assembly 23. The door is now ready to be installed on the dryer. To ease this step, the hinge has keyholes that allow a partially fastened screw to be used as a hook. Partially fasten a screw to the uppermost screw hole. Hook the door on the partially fastened screw. Fasten the hinge by installing the other 4 screws and tightening the partially fastened screw above. Consumer Support