GE GFDN160GJWW Use and Care Manual - Page 11

Installation Instructions

Get GE GFDN160GJWW PDF manuals and user guides View all GE GFDN160GJWW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Installation Instructions 1 REMOVE THE DOOR ASSEMBLY A. Open the door to approximately 130 degrees. 2 REMOVE HINGE AND COVER IMPORTANT: Note the location of the hinge (left or right) before removing. A. Remove the 6 machine screws from the hinge and the 2 machine screws from the hinge cover. Hinge Cover B. Remove the 6 tapping screws located around the perimeter of the door outlining the gasket. Remove the outer ring. Hinge B. With the screws removed, turn the door over and separate the outer door assembly and hinge cover of the door from the door frame and set aside. Hinge Cover C. Remove 3 hinge screws starting at the bottom and move up. Make sure the door is supported while removing the screws. Hinge 3 REINSTALL HINGE ASSEMBLY A. Place the hinge in the opposite side of the door as shown. Push the hinge in place until the hinge holes align with the door holes. Then loosen top screw, remove door and remove screw First remove three lower hinge screws D. Loosen the top screw as shown. Unhook the door by lifting and pulling. Remove the top screw. 11 Hinge shown on opposite side

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
11
REMOVE THE DOOR ASSEMBLY
A.
Open the door to approximately 130 degrees.
1
REMOVE HINGE AND COVER
IMPORTANT:
Note the location of the hinge (left or
right) before removing.
A.
Remove the 6 machine screws from the hinge
and the 2 machine screws from the hinge cover.
Installation Instructions
B.
Remove the 6 tapping screws located around
the perimeter of the door outlining the gasket.
Remove the outer ring.
C.
Remove 3 hinge screws starting at the bottom
and move up. Make sure the door is supported
while removing the screws.
REINSTALL HINGE ASSEMBLY
A.
Place the hinge in the opposite side of the door
as shown. Push the hinge in place until the hinge
holes align with the door holes.
D.
Loosen the top screw as shown. Unhook the door
by lifting and pulling. Remove the top screw.
First remove
three lower
hinge screws
Then loosen top
screw, remove door
and remove screw
2
B.
With the screws removed, turn the door over and
separate the outer door assembly and hinge cover
of the door from the door frame and set aside.
3
Hinge
Hinge
Cover
Hinge
Hinge
Cover
Hinge shown
on opposite
side