GE GFDN160GJWW Use and Care Manual - Page 7
Ext Tumble/Wrinkle Care, Damp Alert, Volume, Lock Control, Clean Filter Message, Display, My Cycle
View all GE GFDN160GJWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
10 11 12 13 14 15 16 My Cycle GEAppliances.com Damp Alert This option causes the dryer to beep when clothes have dried to a damp level. Remove items that you wish to hang dry. The Damp Alert will only beep when this option is selected, and the dryer will continue to dry. Removing clothes and hanging them when they are damp can reduce the need to iron some items. Ext Tumble/Wrinkle Care Minimizes wrinkles by adding approximately 60 minutes of no-heat tumbling after clothes are dry. The beeper will sound every five minutes as a reminder to remove the clothes. Volume Alerts you that the cycle is complete. The beeper will continue to sound every minute for the next 5 minutes, until the clothes have been removed. The clothes should be removed when the beeper goes off so wrinkles don't set in. Lock Control You can lock the controls to prevent any selections from being made. Or you can lock or unlock the controls after you have started a cycle. Children cannot accidentally start the dryer by touching buttons with this option selected. To lock the dryer, press and hold the Lock Control button for 3 seconds. The estimated time remaining display will show "0:00". The extended tumble time does not get added to the cycle time on the display. Press Volume to select low, medium or high volume, or to turn the beeper off. To turn on or off the sounds the buttons make when pressed, press and hold the Volume button for 3 seconds. To unlock the dryer controls, press and hold the Lock Control button for 3 seconds. A sound is made to indicate the lock/unlock status. The indicator light above the button will illuminate when the controls are locked. NOTE: The Power button can still be used when the machine is locked. Clean Filter Message This message represents only a reminder and does not always appear when the filter needs cleaning. The filter should be cleaned after every drying cycle is complete. Display Displays the approximate time remaining until the end of the cycle. As the cycle begins, you will see an initial approximate total cycle time in the display. This message will disappear after the Start/ Pause button is pressed. Even though you may have already cleaned the filter (before or after the Power button has been pressed), the "Clean Filter" message will still be displayed until the Start/Pause button is activated. Then lights will "race" in the display. This means the dryer is continuously monitoring the amount of moisture in the load. The lights will continue until the dryer senses a low level of moisture in the load. At that point, the dryer will calculate and display the approximate time remaining. My Cycle (on some models) Set up your favorite combination of settings and save them here for one touch recall. These custom settings can be set while a cycle is in progress. To store a My Cycle combination of settings: 1. Select your drying cycle. 2. Change Temp and Level settings to fit your needs. 3. Select any drying options you want. 4. Press and hold the My Cycle button for 3 seconds to store your selection. A beep will sound and the button will light up. To recall your stored My Cycle combination: Press the My Cycle button before drying a load. To change your stored My Cycle combination: Repeat steps 1-4. 7