GE GMR04HASCS Use and Care Manual - Page 10

Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions Preparing to install the refrigerator. Hinge cover Plug buttons or screws Plug button Hinge Spacer Bottom hinge Leveling legs Door Reversal (on some models) 1. Remove the small plug button on the left side of the door top cap. 2. Remove the three plug buttons or screws on the left side on top of the cabinet. 3. Remove the plastic hinge cover by lifting it up by the front edge. 4. Remove the three screws from the top hinge. 5. Lift the door up and off the bottom hinge (right side). 6. Tilt the refrigerator cabinet back to remove the right leveling leg. 7. Remove the screws on the bottom hinge (right side) and the left leveling leg. Move the bottom hinge to the left side and secure it with the screws and leveling leg. IMPORTANT: The left leg has a spacer that must be moved to the right side leveling leg when the door swing is reversed. 8. Screw the right leveling leg, with the spacer in place, back in place on the right side. 9. Position the door on the left bottom hinge. With the magnetic gasket holding the door in place, secure the top hinge with screws. 10. Make sure the door is aligned with the refrigerator cabinet before continuing. 11. Replace the hinge cover on top of the hinge. 12. Put the plug button in the hole on the right side of the door cap. 13. Put the three plug buttons or screws on the right side on top of the cabinet. 10