GE GMR04HASCS Use and Care Manual - Page 11

Top cover Left hinge location Plug button Spacer ge.com Upper hinge Top plate Door top cap Bottom hinge Leveling legs Door Reversal (on some models) 4 Cubic Foot Models 1. Remove the two screws at the back of the top cover. 2. Remove the top cover by lifting the back up about 2″ and then sliding it forward. 3. Remove the small plug button on the left side of the door top cap. 4. Remove the three screws on the upper hinge (right side). Remove the hinge. 5. Remove the three screws at the left hinge location on the top plate. 6. Remove the screw in the middle of the top plate and remove the top plate. 7. Lift the door up and off the bottom hinge (right side). 8. Tilt the refrigerator cabinet back to remove the right leveling leg. 9. Remove the screws on the bottom hinge (right side) and the left leveling leg. Move the bottom hinge to the left side and secure it with the screws and leveling leg. IMPORTANT: The left leg has a spacer that must be moved to the right side leveling leg when the door swing is reversed. 10. Screw the right leveling leg, with the spacer in place, back in place on the right side. 11. Position the door on the left bottom hinge. With the magnetic gasket holding the door in place, secure the top hinge with screws. 12. Make sure the door is aligned with the refrigerator cabinet before continuing. 13. Replace the top plate and screws. 14. Slide the top cover back in place and replace the two screws. 15. Put the plug button in the hole on the right side of the door top cap. 11 Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support