GE GTDS855EDMC Use and Care Manual - Page 13
When you finish
View all GE GTDS855EDMC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
GEAppliances.com 5 Remove and swap the 2 cover caps and door handle from the outer door: A. Squeeze the tabs on the inside of the door handle clips. Push clips through the outer door. B. Squeeze the tabs on the inside of the cover caps. Push caps through the outer door. 6 With the cover caps and door handle in place, mount the inner door back into the outer door with the screws removed in step 4. Make sure you mount the hinges on the side opposite the handle. Inside screws Door hinge screws Cover caps Inside of door Door handle Door handle clip Edge screws Handle Inside screws 7 Mount the assembled door on the 2 upper left side hinge screws installed in step 2. Move the hinge screws loosened in step 3 into the lower left side screw holes and firmly tighten all 4 screws. C. Push the door handle clips into the openings on the opposite side of the outer door making sure you flip the handle so it curves to the inside. Door D. Push the cover caps into the openings on the outer door where the handle was removed. Inside of door Cover cap Door handle clip Door handle Hang door and tighten screws 8 Install the 4 plastic caps removed in step 1 into the 4 right side front panel holes. NOTE: To return the door to the original setup, follow these instructions, swapping "left" and "right". When you finish Plug the dryer back into its electrical outlet. 13