GE JM250DFCC Installation Instructions
GE JM250DFCC Manual
 |
View all GE JM250DFCC manuals
Add to My Manuals
Save this manual to your list of manuals |
GE JM250DFCC manual content summary:
- GE JM250DFCC | Installation Instructions - Page 1
Door 20 Lift-Up Cooktop 22 Light 21 Painted Surfaces 21 Porcelain Enamel Cooktop 19 Racks 20 Surface Units 22 Vent 19 Troubleshooting Tips . . . 23-25 Accessories 26 Consumer Support Consumer Support . . . . . Back Cover Warranty 27 Owner's Manual JM250 JMP31 Write the model and serial - GE JM250DFCC | Installation Instructions - Page 2
INSTRUCTIONS BEFORE USING. WARNING For your safety, the information in this manual must be followed to minimize the risk of fire, electric these instructions can result in death or serious burns to children or adults. Method 1 Raise the lift-up cooktop and support it with the cooktop support rod - GE JM250DFCC | Installation Instructions - Page 3
Be sure your appliance is properly installed and grounded by a qualified installer in accordance with the provided installation instructions. „Do not attempt to repair or replace any part of your range unless it is specifically recommended in this manual. All other servicing should be transferred - GE JM250DFCC | Installation Instructions - Page 4
service light goes INSTRUCTIONS (some models) „ Do not immerse or soak the removable surface units. Do not put them in a dishwasher. Do not self-clean the surface units in an oven. Doing so may cause them to fail, presenting a burn or fire hazard. „ To avoid the possibility of a burn or electric - GE JM250DFCC | Installation Instructions - Page 5
of any kind should be used in or around any part of the oven. „If the self-cleaning mode malfunctions, turn the oven off and disconnect the power supply. Have it serviced by a qualified technician. WARNING WARMING DRAWER SAFETY INSTRUCTIONS (some models) „ The purpose of the warming drawer is - GE JM250DFCC | Installation Instructions - Page 6
INSTRUCTIONS BEFORE USING. WARNING SURFACE COOKING INSTRUCTIONS parts and wiring. „2QO\FHUWDLQW\SHVRIJODVVJODVVøFHUDPLFHDUWKHQZDUH or other glazed containers are suitable for cooktop service „ To avoid the possibility of a burn or electric shock, always be certain that the controls for - GE JM250DFCC | Installation Instructions - Page 7
manual level you set. A surface unit ON indicator light will glow when any surface unit is on. castiron cookware are slow to absorb heat, but generally cook evenly at low to medium heat settings your local retail store. Do not use woks that have support rings. Use of these types of woks, with or - GE JM250DFCC | Installation Instructions - Page 8
Using the oven controls. Throughout this manual, features and appearance may vary from your model. Oven Control, Clock and Timer Features and Settings BAKE Pad Press this pad to select the bake - GE JM250DFCC | Installation Instructions - Page 9
Special features of your oven control. GEAppliances.com Your new touch pad control has additional features that you may choose to use. The following are the features and how you may activate them. The special feature modes can only be activated while the display is showing the time of day. They - GE JM250DFCC | Installation Instructions - Page 10
Special features of your oven control. Tones at the End of a Timed Cycle At the end of a timed cycle, 3 short beeps will sound followed by one beep every 6 seconds until the CLEAR/OFF pad is pressed. This continual 6-second beep may be canceled. To cancel the 6-second beep: Press the BAKE and BROIL - GE JM250DFCC | Installation Instructions - Page 11
GEAppliances.com Cook and Hold Your new control has a cook and hold feature that keeps cooked foods warm for up to 3 hours after the cooking function is finished. This feature can be used only at the end of a timed baking cycle which has an automatic stop. To activate this feature, follow the steps - GE JM250DFCC | Installation Instructions - Page 12
The racks have stop-locks, so that when placed correctly on the supports, they will stop before coming completely out, and will not tilt. When or C NOTE: A cooling fan may automatically turn on and off to cool internal parts. This is normal, and the fan may continue to run even after the oven is - GE JM250DFCC | Installation Instructions - Page 13
the Oven for Broiling Place the meat or fish on a broiler grid in a broiler pan designed for broiling. Follow suggested rack positions in the Broiling Guide. If your oven is connected to 208 volts, rare steaks may be broiled by preheating the broiler and positioning the oven rack one position higher - GE JM250DFCC | Installation Instructions - Page 14
Using the clock and timer. Make sure the clock is set to the correct time of day. To Set the Clock The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle. Press the - GE JM250DFCC | Installation Instructions - Page 15
be allowed to sit for more than 1 hour before or after cooking. Room temperature promotes the growth of harmful bacteria. Be sure that the oven light is off because heat from the bulb will speed harmful bacteria growth. The low temperature zone of this range (between 170°F and 200°F) is available - GE JM250DFCC | Installation Instructions - Page 16
$GMXVWWKHRYHQWKHUPRVWDW³'RLW\RXUVHOI You may find that your new oven cooks differently than the one it replaced. Use your new oven for a few weeks to become more familiar with it. If you still think your new oven is too hot or too cold, you can adjust the thermostat yourself. Do not use - GE JM250DFCC | Installation Instructions - Page 17
notice it becoming worn or frayed, replace it. Wipe up any heavy spillovers on the oven bottom. Make sure the oven light bulb cover is in place and the oven light is off. IMPORTANT: The health of some birds is extremely sensitive to the fumes given off during the self-cleaning cycle - GE JM250DFCC | Installation Instructions - Page 18
to open the oven door until the temperature drops below the lock temperature and the LOCKED DOOR light goes off. The oven shuts off automatically when the clean cycle is complete. When the LOCKED DOOR light is off, open the door. Press the START pad. After a Clean Cycle You may notice some - GE JM250DFCC | Installation Instructions - Page 19
electrical power is off and all surfaces are cool before cleaning any part of the range. If your range is removed for cleaning, servicing or the safest way to remove the adhesive from packaging tape on new appliances is an application of a household liquid dishwashing detergent. Apply with a soft - GE JM250DFCC | Installation Instructions - Page 20
slide. It will be necessary to grease all oven rack side edges with a light coating of vegetable oil after cleaning them by hand or in the oven. This will up and off the hinges. The oven door is removable for easier access to the light bulb. Do not lift the door by the handle. To remove the door, - GE JM250DFCC | Installation Instructions - Page 21
on any painted surface. Oven Light Replacement CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the cover. Replace bulb with a 40-watt appliance bulb. To replace the cover: Place it into groove of the light receptacle. Pull wire forward to the center - GE JM250DFCC | Installation Instructions - Page 22
unit through the opening in the drip pan and into the receptacle. Guide the surface unit into place so it rests evenly. Do not immerse removed; however, you may remove one to make raising the cooktop easier. A support rod will hold the cooktop up while you clean underneath it. After cleaning under - GE JM250DFCC | Installation Instructions - Page 23
Service... Troubleshooting Tips Save time and money! Review the charts on the following pages first and you may not need to call for service. GEAppliances.com Problem Make sure you press the BROIL HI/LO pad. • See the Broiling Guide. • For best results, use a pan designed for broiling. Make sure - GE JM250DFCC | Installation Instructions - Page 24
Before You Call For Service... Troubleshooting Tips Problem Control signals after entering cooking time or delay CLEAR/OFF pad. Open the windows to rid the room of smoke. Wait until the LOCKED DOOR light goes off. Wipe up the excess soil and reset the clean cycle. Oven door will not open after - GE JM250DFCC | Installation Instructions - Page 25
Problem "LOCK DOOR" flashes in the display Possible Causes What To Do The self-clean cycle has been • Close the oven door. selected but the door is not closed. LOCKED DOOR light reconnect power. If the function error code repeats, call for service. Display goes blank A fuse in your home may be - GE JM250DFCC | Installation Instructions - Page 26
Pans Knobs or Oven Racks Oven Elements Light Bulbs ([SHULHQFHWKHVHRWKHUJUHDWSURGXFWV Stainless Steel Appliance Polish Wipes Stainless Steel Appliance Cleaner WX10X117GCS pan below catches the excess fats and oils. • Genuine GE Part • Easy To Clean • One-Year Warranty /LPLWHG7LPH2IIHU - GE JM250DFCC | Installation Instructions - Page 27
GE will also provide, free of charge, all labor and in-home service to replace the defective part. What GE Will Not Cover: „ Service appliance. „ Damage caused after delivery. „ Product not accessible to provide required service General. Warrantor: General Electric Company. Louisville, KY 40225 27 - GE JM250DFCC | Installation Instructions - Page 28
Support. GE Appliances Website GEAppliances.com Have a question or need assistance with your appliance? Try the GE Appliances Website 24 hours a day, any day of the year! For greater convenience and faster service, you can now download Owner's Manuals, order parts or even schedule service
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
 |
 |
GEAppliances.com
JM250
JMP31
Owner’s Manual
49-80647-1
07-13
GE
Safety Instructions
........
2–6
Operating Instructions
Broiling, Broiling Guide
..........
13
Clock and Timer
.................
14
Oven
.........................
8–18
Self-Cleaning
.................
17, 18
Special Features
..............
9–11
Surface Units
.....................
7
Thermostat
......................
16
Timed Baking and Roasting
......
15
Care and Cleaning
Aluminum Foil
...................
12
Control Panel and Knobs
........
19
Drip Pans
.......................
22
Heating Elements
...............
21
Lift-Off Oven Door
...............
20
Lift-Up Cooktop
..................
22
Light
............................
21
Painted Surfaces
................
21
Porcelain Enamel Cooktop
.......
19
Racks
...........................
20
Surface Units
........................
22
Vent
............................
19
Troubleshooting Tips
. . . 23–25
Accessories
..................
26
Consumer Support
Consumer Support
.....
Back Cover
Warranty
.......................
27
Write the model and serial
numbers here:
Model # _______________
Serial # ________________
You can find them on a label
behind the range door.
Ranges
Electric