GE JVM6172SKSS Installation Instructions - Page 14

Installation Instructions A4. ADAPTING BLOWER FOR OUTSIDE VENTILATION (Cont.) 7 Place the blower unit back into the opening. CAUTION Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. 8 Close the blower door. Secure the blower to the microwave using the screws from Step 1. A5. CHECK FOR PROPER DAMPER OPERATION Damper A6. MOUNT THE MICROWAVE OVEN CAUTION FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws. NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. Blower Plate Exhaust Adaptor Retaining Hooks Back of Microwave Oven • Place the microwave in its upright position, with the top of the unit facing up. • Make sure tape securing damper is removed and damper pivots easily before mounting microwave. • Slide the damper into place. Make sure it catches in the retaining hooks to secure. • You will need to make adjustments to assure proper alignment with your house exhaust duct after the microwave is installed. 2 Rotate front of oven up against cabinet bottom. 3 Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. 14