GE JVM6172SKSS Installation Instructions - Page 22
Adapting Microwave Blower, For Recirculation Cont., Mount The Microwave Oven
View all GE JVM6172SKSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installation Instructions C4. ADAPTING MICROWAVE BLOWER FOR RECIRCULATION (cont.) 6 Remove the metal vent fan cover on the back of the microwave by sliding it up. C5. MOUNT THE MICROWAVE OVEN 7 Close the blower door. Slide blower shield onto the top of the blower door opening. 8 Secure the blower to the microwave using the blower retaining screws from Step 1. Blower Retaining Screw Blower Retaining Screws Back of Microwave Oven CAUTION FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws. NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. 2 Rotate front of oven up against cabinet bottom. 22