GE PB970 Installation Instructions - Page 9
Level The Range, Final Installation, Checklist, Operation Checklist - manual
View all GE PB970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation Instructions 11 LEVEL THE RANGE A Install the oven shelves in the oven and position the range where it will be installed. B Check for levelness by placing a spirit level or a cup, partially filled Spirit level with water, on one of the oven shelves. If using a spirit level, take two readings-with the level placed diagonally first in one direction and then the other. C The front and rear leveling legs can be adjusted from the bottom. Leg leveler Raise range Lower range D Use an open-end or adjustable wrench to adjust the leveling legs until the range is level. 12 FINAL INSTALLATION CHECKLIST • Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced. • Be sure power is in service to the building. • Check to be sure that all packing materials and tape have been removed. This will include tape on metal panel under control knobs (if applicable), adhesive tape, wire ties, cardboard and protective plastic. Failure to remove these materials could result in damage to the appliance once the appliance has been turned on and surfaces have heated. • Check to make sure that the doors are parallel to each other and that both operate smoothly. If they do not, see the Owner's Manual for proper replacement. • Check to make sure that the rear leveling leg is fully inserted into the Anti-Tip bracket and that the bracket is securely installed. 13 OPERATION CHECKLIST • Turn on one of the surface units to observe that the element glows within 60 seconds. Turn the unit off when glow is detected. If the glow is not detected within the time limit, recheck the range wiring connections. If change is required, retest again. If no change is required, have building wiring checked for proper connections and voltage. • Check to make sure the Clock (on models so equipped) display is energized. If a series of horizontal red lines appear in the display, disconnect power immediately. Recheck the range wiring connections. If change is made to connections, retest again. If no change is required, have building wiring checked for proper connections and voltage. It is recommended that the clock be changed if the red lines appear. • Be sure all range controls are in the OFF position before leaving the range. 9