GE PEB2060SMSS Installation Instructions - Page 1
GE PEB2060SMSS - Countertop Microwave Oven Manual
UPC - 084691164166
View all GE PEB2060SMSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Instructions Built-In Trim Kits JX2027 and JX2030 Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com ❒ BEFORE YOU BEGIN Read these instructions completely and carefully. • Do not alter or modify any part of this kit or the oven. IMPORTANT - • Save these instructions for local inspector's use. IMPORTANT - • Observe all governing codes and • Unplug the microwave oven before attempting installation of this kit. • Skill level - Installation of this appliance requires basic mechanical and electrical skills. • Completion time - 1-3 hours ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. • This kit is UL listed for installation alone or over any GE/GE Profile single electric wall oven. Not for use adjacent to (within 2 feet of) any gas • For easier installation and personal safety, we recommend that two people or electric range, cooktop or oven. install this microwave oven. • This kit is for use on models: PEB2060DMBB, PEB2060DMWW, WARNING - This oven must be plugged into a properly PEB2060DMCC, PEB2060SMSS, JEB1860DMBB, JEB1860DMWW, JEB1860DMCC and JEB1860SMSS. grounded 3-hole, 120V receptacle as required by the National Electrical Code. FOR YOUR SAFETY: WARNING - Before beginning the installation, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. TOOLS YOU WILL NEED ❒ Phillips screwdriver ❒ Pencil ❒ Drill with 7⁄64″ bit or #35 PARTS INCLUDED PART ❒ Trim Frame QUANTITY 1 ❒ Bottom Duct 1 ❒ Side Duct 1 ❒ 4 mm x 12 mm Round-Head Screws ❒ 4 mm x 14 mm Flat-Head Screws 23 (21 required for installation) 6 (4 required for installation) ❒ Anti-Tip Brace 1 ❒ Anti-Tip Bracket 1 ❒ Awl or punch ❒ Level ❒ Tape measure ❒ Scissors (optional) READ CAREFULLY. KEEP THESE INSTRUCTIONS. ❒ Upper Duct 1 ❒ Top Bracket 1 ❒ Bottom Bracket 1 ❒ Templates 2 NOTE: This kit has extra screws to prevent the technician from spending extra 1 time locating a replacement screw in case they lose one during installation.