GE PSB2200NBB Installation Instructions - Page 8

Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL ZSC2202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING (CONT.) Installation over a GE/Monogram Oven: 30" 23-1/2" Construct Solid Bottom Min. 3/8" Plywood Supported by 25-1/4" Min.* 2x4 or 2x2 Runners all Four Sides PREPARE THE OPENING (CONT.) Installation over a GE/Monogram Oven and Warming Drawer: Construct Solid 30" 23-1/2" Bottom Min. 3/8" Plywood Supported by 2x4 or 2x2 Runners all 25-1/4" Four Sides Min.* 21" 45-1/4" Min. 2" Min. (3" recommended) Per Oven Requirement 21" 2" Min. (3" recommended) Per Oven Requirement 45-1/4" 2" Min. Min. Per warming drawer requirement * For existing cutouts, a maximum width of 28-1/2" is acceptable. If the opening is slightly wider, secure a furring strip on each side of the cutout for securing the oven. • If you are replacing a GE/Monogram electric double oven with the combined installation of an Advantium 240V and a single oven, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 2" minimum shown. * For existing cutouts, a maximum width of 28-1/2" is acceptable. If the opening is slightly wider, secure a furring strip on each side of the cutout for securing the oven. NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. See Warming Drawer installation instructions for details. CAUTION: For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of this approximate 80-pound oven and 30-pound drawer, plus additional oven loads of up to 50 pounds or a total weight of 160 pounds. 8