GE PVM9005EJES Installation Instructions - Page 23
Mount The Microwave Oven, Adapting Blower For, Outside Back Exhaust, Cont.
View all GE PVM9005EJES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Installation Instructions C4 ADAPTING BLOWER FOR OUTSIDE BACK EXHAUSTcont. 6 Gently place the fan back into the cavity with the exhaust portion of the fan at the top and facing the back of the unit. C5 MOUNT THE MICROWAVE OVEN Note: Make sure the wires remain routed through the openings in the motor frame. To avoid damage to the fan motor wiring, insert motor carefully such that the fan motor wiring does not contact the microwave power cord bracket. 7 Replace screw on the back of the unit. Screw 8 Slide the vent damper on back of the unit with the hinge at the top. Slide exhaust adaptor into guides on microwave oven rear. Damper (hinge side up) Exhaust Adaptor Locking Back of Tabs Microwave Oven 9 Replace the vent cover on the unit and secure it to the unit by replacing the two screws that were removed, with one in the middle hole and one on either side. CAUTION: 7RDYRLGWKHULVNRISHUVRQDO LQMXU\EDFNLQMXU\RURWKHULQMXULHVGXHWRH[FHVVLYH ZHLJKWRIWKHPLFURZDYH RUSURSHUW\GDPDJH\RX ZLOOQHHGWZRSHRSOHWRLQVWDOOWKLVPLFURZDYH IMPORTANT: Do not grip or use handle during installation. WARNING: 5LVNRI(OHFWULF6KRFN&DQ FDXVHLQMXU\RUGHDWK,ILQVWDOOLQJXQLWZLWKPHWDO FRXQWHUWRSVFRYHUWKHHGJHRIWKHSRZHUVXSSO\ FRUGKROHZLWKWKHSRZHUVXSSO\FRUGEXVKLQJ IMPORTANT: If filler blocks are not used, case damage may occur from overtightening screws. NOTE: When mounting the microwave, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift microwave oven by pulling cord. 1 Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. Power Cord Side Tab Side Slot Rear Tab Rear Slot 2 Rotate front of microwave oven up against cabinet bottom. 23