GE WSM2700WWW Installation Instructions

GE WSM2700WWW - 27" Unitized Spacemaker Washer Manual

Get GE WSM2700WWW - 27inch Unitized Spacemaker Washer PDF manuals and user guides View all GE WSM2700WWW manuals
Add to My Manuals
Save this manual to your list of manuals

GE WSM2700WWW manual content summary:

  • GE WSM2700WWW | Installation Instructions - Page 1
    as described in these instructions. IMPORTANT • Exhausting the dryer to the outside is required to prevent large amounts of moisture, lint and other products of combustion from being blown into the room. • Service information and a wiring diagram are located in the dryer access panel. PRODUCT
  • GE WSM2700WWW | Installation Instructions - Page 2
    Installation Instructions UNPACKING SPACEMAKER™ pliers. 5 Return the appliance to the upright position and locate it in the general area to be installed. Provide enough space at the rear for installing the water CONNECTION SEE ELECTRICAL CONNECTION INFORMATION Tub blocking pad Dryer support pads 2
  • GE WSM2700WWW | Installation Instructions - Page 3
    Installation Instructions MOVING SPACEMAKER™ TO OPERATING LOCATION 10 Remove the 2 screws securing the access panel to the dryer cabinet. Lift the front access panel until the tabs can be disengaged from the dryer cabinet and remove the panel. 11 Route the inlet hoses, drain hose and power cord
  • GE WSM2700WWW | Installation Instructions - Page 4
    leaks. 17D Turn on electricity at the power source. 17E Turn on the washer and dryer and run through one cycle. Check all hoses for leaks. REPLACING FRONT ACCESS PANEL 18 Reinstall front access panel removed in Step 10. 19 Place the Owner's Manual and Installation Instructions in a location where
  • GE WSM2700WWW | Installation Instructions - Page 5
    Instructions CONNECTING APPLIANCE USING 3-WIRE CONNECTION 1 Remove the terminal block cover located at the rear of the dryer. terminal block cover. CAUTION: Be sure electricity is OFF at power source (circuit breaker/fuse box). 8 Plug power cord into electrical outlet. 9 Return to Step 15
  • GE WSM2700WWW | Installation Instructions - Page 6
    flexible metal (semi-rigid or foil-type) duct to connect the dryer to the home exhaust duct. It must be installed in accordance with the instructions found in "Connecting the Dryer to House Vent" on page 7 of this manual. • Do not terminate exhaust in a chimney, a wall, a ceiling, gas vent, crawl
  • GE WSM2700WWW | Installation Instructions - Page 7
    Instructions The male end of each section of duct must point away from the dryer. • Do not assemble ductwork with fasteners that extend into the duct. be insulated to reduce condensation and lint buildup. PARTS AVAILABLE FROM LOCAL SERVICE ORGANIZATIONS • Rigid Metal Duct Components WX8X63 WX8X64
  • GE WSM2700WWW | Installation Instructions - Page 8
    Part 32-80. • The dryer must be exhausted to the outside with the termination securely fastened to the mobile home structure. • The exhaust MUST NOT be terminated beneath the mobile home. • The exhaust duct material MUST NOT support combustion. • For Electrical INSTALLATION AND SERVICE. CAUTION: DO
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
WARNING –
POTENTIAL FIRE AND SHOCK HAZARD
•
To reduce the risk of severe injury or death, follow all installation instructions.
•
Clothes dryer installation must be performed by a qualified installer.
•
Install the clothes dryer according to these instructions and in accordance with local codes.
•
This dryer must be exhausted to the outdoors.
•
Use only 4" rigid metal ducting for exhausting the clothes dryer to the outdoors.
•
DO NOT install a clothes dryer with flexible plastic ducting materials. If flexible metal (semi-rigid or foil-type) duct is installed,
it must be UL-listed and installed in accordance with the instructions found in "Connecting the Dryer to House Vent" on page
7 of this manual. Flexible ducting materials are known to collapse, be easily crushed, and trap lint. These conditions will
obstruct dryer airflow and increase the risk of fire.
•
Do not install or store this appliance in any location where it could be exposed to water and/or weather.
•
Save these instructions. (Installers: Be sure to leave these instructions with the customer.)
•
This appliance must be properly grounded and installed as described in these instructions.
Installation instructions
Spacemaker
™
for your new
Laundry
WSM2700 Electric
Before you begin – Read these instructions completely and carefully.
IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer – Be sure to leave these instructions with the Consumer.
Note to Consumer – Keep these instructions with your Owner’s Manual for future reference.
TOOLS NEEDED
IMPORTANT
•
Exhausting the dryer to the outside
is required to prevent large
amounts of moisture, lint and other
products of combustion from being
blown into the room.
•
Service information and a wiring
diagram are located in the dryer
access panel.
PRODUCT DIMENSIONS
75
1
⁄
2
″
54
5
⁄
16
″
3
3
⁄
4
″
27
″
Drain outlet
(rear)
Water
inlets (rear)
Vent
9
3
⁄
8
″
29
7
⁄
16
″
41
1
⁄
4
″
25
1
⁄
4
″
16
1
⁄
4
″
2
1
⁄
2
″
47
″
4
13
⁄
16
″
11
7
⁄
16
″
36
1
⁄
16
″
30
13
⁄
16
″
51°
49-90383
05-09 JR
Slip-joint pliers
Phillips-head and flat-blade screwdrivers
Ratchet with 3/8
″
socket
Carpenter’s level
Adjustable wrenches