Gigabyte GA-970A-DS3 Manual - Page 24
CPU Host Clock Control, CPU Frequency MHz, Set Memory Clock, Memory Clock
View all Gigabyte GA-970A-DS3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software DRAM Configuration ProcOdt(ohms) DQS Drive Strength Data Drive Strength MEMCLK Drive Strength Addr/Cmd Drive Strength CS/ODT Drive Strength CKE Drive Strength **DCTs Addr/Cmd Timing** Addr/Cmd Setup Time Addr/Cmd Fine Delay CS/ODT Setup Time CS/ODT Fine Delay CKE Setup Time CKE Fine Delay [Auto] 60 [Auto] 240 [Auto] 1.0x [Auto] 1.0x [Auto] 1.0x [Auto] 1.0x [Auto] 1.25x [Auto] 1.25x [Auto] 1.5x [Auto] 1.5x [Auto] 1.5x [Auto] 1.5x [Auto] 1.5x [Auto] 1.5x DCT0 DCT1 [Auto] 1/2T [Auto] 1/2T [Auto] 0/64 [Auto] 0/64 [Auto] 1/2T [Auto] 1/2T [Auto] 0/64 [Auto] 0/64 [Auto] 1/2T [Auto] 1/2T [Auto] 0/64 [Auto] 0/64 Item Help Menu Level Channel Interleaving Bank Interleaving DQS Training Control CKE Power Down Mode Memclock tri-stating [Enabled] [Enabled] [Skip DQS] [Disabled] [Disabled] Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults && CPU Host Clock Control, CPU Frequency (MHz), Set Memory Clock, Memory Clock The settings under the four items above are synchronous to those under the same items on the MB Intelligent Tweaker(M.I.T.) main menu. && DCTs Mode Allows you to set memory control mode. Ganged Sets memory control mode to single dual-channel. Unganged Sets memory control mode to two single-channel. (Default) && DDR3 Timing Items Manual allows all DDR3 Timing items below to be configurable. Options are: Auto (default), Manual. && 1T/2T Command Timing Options are: Auto (default), 1T, 2T. && CAS# latency Options are: Auto (default), 5T~14T. && RAS to CAS R/W Delay Options are: Auto (default), 2T~19T. && Row Precharge Time Options are: Auto (default), 2T~19T. && Minimum RAS Active Time Options are: Auto (default), 8T~40T. && TwTr Command Delay Options are: Auto (default), 4T~9T. && Trfc0 for DIMM1, DIMM3 Options are: Auto (default), 90ns, 110ns, 160ns, 300ns, 350ns. && Trfc1 for DIMM2, DIMM4 Options are: Auto (default), 90ns, 110ns, 160ns, 300ns, 350ns. - 24 -