Gigabyte GA-EP45-UD3P Manual - Page 27
GSATA2_0/GSATA2_1 SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple, Controlled by ICH10R - raid
UPC - 818313006530
View all Gigabyte GA-EP45-UD3P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
8) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by ICH10R, Orange) jk The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The ICH10R controller supports RAID 0, RAID 1, RAID 5, and RAID 10. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. SATA2_4 7 7 SATA2_5 SATA2_2 SATA2_3 Pin No. Definition SATA2_0 1 GND 1 2 TXP 1 3 TXN SATA2_1 4 GND 5 RXN 6 RXP 7 GND 9) GSATA2_0/GSATA2_1 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The GIGABYTE SATA2 controller supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. Pin No. Definition 1 GND 17 2 TXP 3 TXN GSATA2_0 GSATA2_1 4 GND 5 RXN 71 6 RXP 7 GND j Only for GA-EP45-UD3P. k Only for GA-EP45-UD3R. Please connect the L-shaped end of the SATA 3Gb/s cable to your SATA hard drive. • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. • A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) • A RAID 10 configuration requires at least four hard drives and the total number of hard drives must be an even number. - 27 - Hardware Installation