Gigabyte GA-MA790FX-UD5P Manual - Page 43

DRAM Configuration CMOS Setup Utility-Copyright (C) 1984-2009 Award Software DRAM Configuration DCTs Mode (Note) CPU Host Clock Control x CPU Frequency (MHz) Set Memory Clock x Memory Clock DDRII Timing Items x CAS# latency x RAS to CAS R/W Delay x Row Precharge Time x Minimum RAS Active Time x 1T/2T Command Timing x TwTr Command Delay x Trfc0 for DIMM1 x Trfc2 for DIMM2 x Trfc1 for DIMM3 x Trfc3 for DIMM4 x Write Recovery Time x Precharge Time x Row Cycle Time [Unganged] [Auto] 200 [Auto] x2.66 533Mhz [Auto] SPD Auto 7T Auto 7T Auto 7T Auto 20T Auto - - Auto 5T Auto 90ns Auto - - Auto - - Auto - - Auto 10T Auto 3T Auto 11T Auto 5T 4T 4T 12T - 2T 90ns - - - 10T 3T 11T Item Help Menu Level Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults x RAS to RAS Delay CMOS Setup Utility-Copyright (C) 1984-2009 Award Software MB Intelligent Tweaker(M.I.T.) Auto 4T 4T Item Help Menu Level Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults DCTs Mode (Note) Allows you to set memory control mode. Ganged Sets memory control mode to single dual-channel. Unganged Sets memory control mode to two single-channel. CPU Host Clock Control, CPU Frequency (MHz), Set Memory Clock, Memory Clock The settings under the four items above are synchronous to those under the same items in the MB Intelligent Tweaker(M.I.T.). DDRII Timing Items Manual allows all DDR2 Timing items below to be configurable. Options are: Auto (default), Manual. (Note) This item is present only if you install a CPU that supports this feature. - 43 - BIOS Setup