Haier AB282AEERA User Manual - Page 24

Installation Procedure For series 122,182 and AB242AEEAA, AB242AEERA, AB282AEEAA, AB282AEERA, AB362AEERA, AB362ACEAA, AB422AEEAA, AB482AEEAA Check whether indoor unit is horizontal with leveler or polythene pipe filled with water , and check that the dimension of the ceiling opening is correct. Take off the lever gauge before install the ornament panel. Fasten the screws to make the height difference between the two sides of indoor unit less than 5mm. First fix it with screws temporally. Fasten the two temporally fixing screws and other two, and tighten the four screws. Connect the wires of synchro-motor. Connect the wire of signal. If no response of remote controller, check whether the wiring is correct, restart remote controller 10 seconds after shut off power supply. Electric control box Install the panel board in the direction shown in the figure. The incorrect direction will result in water leakage, meanwhile swing and signal receiving are displayed that cannot be connected. AB122ACEAA, AB122ACERA, AB182ACEAA POWER SUPPLY: 1PH,220-230V~,50Hz INDOOR UNIT 12 3 TERMINAL BLOCK OUTDOOR UNIT 12 3 TERMINAL BLOCK Y/G L N Y/G 22