Haier AB282AEERA User Manual - Page 27

Installation Procedure 2. Mounting on high ceiling (1) Ornament panel can be mounted on ceiling as high as 3 m. (2) Please install pad as accessary. 1 Cut open the pad along cutting ling. Use part a only and discard part b . (Refer to Fig. 4) 2 Install part a of the pad on the place shown in Fig. 5. Refer to Fig. 6. Cutting line Place it on the frame. Leave no space. a 50 100 b Fig. 4 Part a of the pad Part a of the pad Swing flap motor (3)Wiring on ornament panel Fig. 5 Connecting of wiring of the swing flap motor on ornament panel. (2 places) (Refer to Fit . 10) Fig. 6 Side of ornament panel If connecting is not made, error code (A7) appears on remote controller. So, make proper connecting. Side of indoor unit Fig. 10 Wiring diagram 3. Install ornament panel on indoor unit. For indoor unit installation, please refer to Installation Manual. (1) As shown in Fig.7,match the position of swing flap motor with that of the indoor unit piping hole , so that ormament panel can be placed on to indoor Holding ring 1 2 Piping hole position Hook unit. (2) Installation of ornament panel 1 Place the holding ring on swing flao motor side 2 teporarily on hooks of the indoor unit. (2 pcs) 2 Put the other two holding rings on the hooks at both Swing flap motor side of the indoor unit. (Care should be taken not to push wiring of swing flap motor into seals). 3 3 Screw in all 4 screws under holding ring for about 15mm. (Pancl will rise). 4 4 Adjust the ornament panel as per Fig. 7 to cover opening on the ceiling. 5 Tighten screws to redrce the thickness of seals between ornament and indoor unit to 5-8mm. Fig. 7 Indoor unit Ceiling material Seal 5 _ 8mm If screws are not tighten tight, problems in Fig, 8 might occur. Tighten screws properly. Gas leakage. Gas leakage from roof. Caution If there are still space after tightening of screws, please readjust the height of indoor unit. (Refer to Fig. 9) Ornament panel If indoor unit is at horizontal level and water drainage is smooth, then, indoor unit height can be adjusted throrgh holes at corners of ornament panel. Contamination Mist exists and drop down. Fig. 8 Leave no space. Fig. 9 25