Haier HMV1630DBBB HMV1630 Installation Guide - Page 10
Placement Of The Mounting Plate
View all Haier HMV1630DBBB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
English 1. PLACEMENT OF THE MOUNTING PLATE A. REMOVING THE MICROWAVE OVEN FROM THE CARTON/ REMOVING THE MOUNTING PLATE 1. Remove the installation instructions, filters, glass tray and the small hardware bag. Do Carton not remove the Styrofoam protecting the front of the oven. 2. Fold back all 4 carton flaps fully against Styrofoam carton sides. Then carefully roll the oven and carton over onto the top side. The oven should be resting in the Styrofoam. 3. Pull the carton up and off the oven. Screws 4. Remove and properly discard plastic bags. Mounting Plate 5. Remove the screws from the mounting plate. This plate will be used as the rear wall template and for mounting. Reinstall the screws into the holes where they were removed. B. FINDING THE WALL STUDS 1. Find the studs, using one of the following methods: A. Stud finder - a magnetic device which locates nails. OR B. Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate a stud location. 2. After locating the stud(s), find the center by probing the wall with a small nail to find the edges of the stud. Then place a mark halfway between the edges. The center of any adjacent studs should be 16" (40.6 cm) or 24" (61 cm) from this mark. 3. Draw a line down the center of the studs. THE MICROWAVE MUST BE CONNECTED TO AT LEAST ONE WALL STUD. Wall Studs Center 9