Haier HPB08XCM Manual - Page 8

I _I English Operat•ion Control Panel Display Warning Light 0 OOL DCP=HUM FAN si es El o m LOW 0 O = = POWER MODE SPEED TIMER TEMP/TIME • • • Haier / Power Control Mode Control Fan Speed Control Power Control © The power control turns the unit on and off. Warning Light T Condensed water may accumulate in the unit. If the internal tank becomes full, the warning light will light up and the unit will not operate until the unit has been drained. Mode Control The Mode Control has three settings: • Cool • Dehumidify • Fan The settings are adjusted with Mode Control button. A light will indicate which setting is currently being used. • Cooling Mode When cool mode is selected, the indicator light turns blue. During the cooling mode the air is cooled and hot air is exhausted to the outside through the exhaust tube. Adjust fan speed and air temperature to suit your desired comfort level. Note : The air exchange hoses must vent outside the room when using cool mode. • Dehumidify Mode When dehumidify mode is selected, the indicator light turns yellow. Air is dehumidified as it passes through the unit, without being in full cooling mode. If room temperature is higher than 77 degree Fahrenheit , fan speed can be adjusted; otherwise fan speed is fixed to " Low ". Note:If the unit is to be used as a dehumidifier, do not connect the exhaust hose let the warm air return to the room. Continuous drainage is then necessary. Timer / Temp Set Controls • Fan Mode When fan mode is selected the indicator light will shine green. Air is circulated throughout the room with no cooling. Note: unit does not need to be vented in Fan mode Fan Speed Control The Fan Speed Control has 2 settings: High and Low. Timer • Auto turn off : With machine in running mode, press timer button to Select number of hours you would like the unit to run in air conditioning mode until it automatically shuts off. • Auto turn on : With machine in stand by mode, press timer button to Select number of hours until you would like the unit to automatically start running in air conditioning mode. Timer / Temp set controls • Used for adjusting the timer and thermostat. • The default display is room temperature. • In cooling mode, when "^" or ","" button is pressed, the set temperature is displayed and may be adjusted. After 15 seconds the display will revert back to room temperature. Temperature is only adjustable in cool mode. The time is adjustable between 1-24 hours. Note: By pressing both Timer / Temp set buttons at the same time, the display will toggle between Celsius and Fahrenheit. The temperature cannot be adjusted in the fan or dehumidification modes. After switching the air conditioner off, you must wait 3 minutes before switching it back on again. 7 9