Haier HRF10WNDWW User Manual - Page 8

English Dismantling 1. Fix refrigerator and freezer door by sticking adhesive tape on both sides to hold doors in place. 2. As shown in fig. 1, remove hinge top cover on the upper part of freezer door. Then remove the two screws from the hinge. Take out the hinge by pulling it vertically, and keep it in a safe place. 3. Remove the adhesive tape on freezer door, lift and take the door down, and carefully put it aside. 4. As shown in fig. 2, remove screws of the central hinge, lift and take down the central hinge and pad, and keep them in a safe place. 5. Remove the adhesive tape on refrigerator door, lift and take down refrigerator door, and carefully put it aside. fig. 2 central hinge axle central hinge pad Reinstallation fig.3 bottom hinge door axle 1. As shown in fig 3 remove the door axle and install on the opposite hole with washer pads (2) in place. Now dismantle the lower hinge and install the opposite side with the hinge spacer and washer pads in place. 2. Install refrigerator door: make the left bottom fig. 3 hole of the refrigerator compartment door fall over the lower hinge axle, move the door back and forth to make it straight and in alignment with central hinge. Install the central hinge again, turn the hinge axle until it completely enters the door body, then fix it with screws. 3. Install freezer door: align left bottom hole of freezer door over the central axle. Take hinge and adjust so that hinge axle can be installed in the upper hole of the freezer door; adjust door to make it straight and level. Tighten the screws of upper hinge. 4. Install top hinge cover on the left side. fig. 4 central hinge axle central hinge pad 8 7