Haier LSE-1200 Instruction Manual - Page 3

Codes on Display Screen Remaining time 1 hour and 16 minutes Remaining time 1 minute Setting washing temperature at 60 Setting washing without heating process Setting no Spin process Setting dehydration revolutions 800r/min Code for manual selection of weight, when clothes are less than 1kg Code for manual selection of weight, when clothes are almost full of the roller Start-up keyboard locking function Cancel keyboard locking function Procedure is entirely finished Failure information: locking door function abnormity Processing mode: reclose the door, if there is still any alarm, please contact service people Failure information: draining malfunction Processing mode: rinse the filter of draining pump, examine whether the drainpipe is blocked if there is still any alarm, please contact service people. Failure information: temperature pickup malfuntion Processing mode: please contact the service people. Failure information: fuser malfunction (display after procedure operation) Processing mode: please contact the service people. Failure information: water intake abnormity Processing mode: check whether the water hydraulic pressure is too low or water supply is cut off. Please contact the service people. Failure information: dehumidification and heating abnormity. Processing mode: Please contact the service people. Failure information: superabundant spume in the roller or motor failure Processing mode: inflow water and vent the spume or please contact the service people. Failure information: drying temperature sensor malfunction Processing mode: Please contact the service people. Failure information: waterlevel sensor malfunction Processing mode: Please contact the service people. Failure information: drying waterlevel sensor abnormity Processing mode: check whether the clothes is dried or not, and whether there is water in the roller,Dry it again after the dehumidifying process. If there is still any alarm, please contact the service people. Failure information: The door is not properly closed after the activation of the procedure Processing mode: Reclose the door. If there is still any alarm, please contact the service people. Failure information: when spined, clothes is unevenly distributed Processing mode: Quiver and scatter the clothes to make it even. If there is still any alarm, please contact the service people Part names Detergent distribution drawer Display Door Glass Power cable Earth terminal Screws for rear panel Drainage hose Programme selector Control panel Function button Door handle Skirting Hose clip Bolts for transport Rear panel Caution and Warning Symbols For your safety, any instructions in this manual with this "Warning" sign shall be strictly followed. For your safety and to prevent damages to the washing machine, any instructions in this manual with this "Stop" sign shall be strictly followed. This diagram may vary slightly with the layout of the washing machine you have just purchased due to technical improvements.