Haier LSE-1200 Instruction Manual - Page 6

Precaution 3.Do not place heavy objects or container with water on the washing machine,so as to prevent deformation of the flat surface and plastic parts. 4. Do not wash articles containing polystyrene or similar elastic materials. 5. Before washing, do up zippers and ensure 6.Do not open the detergent drawing that buttons are securely fastened. Place during the wash cycle. small items, such as socks,belts,etc. in a small washing bag or a pillow-case . To protect the washing machine, do not wash garments containing wire parts. 7. The door is fitted with a self-lock device 8. At the end of the wash cycle, turn off the and can not be opened until 2-3 minutes water supply to prevent water leakage, un- after the end of the programme.You are not plug the washing machine and thoroughly recommended not to force the door open before the programme end. Do not open the door if the water level is above the lower clean the trim so as not to dirty the laundry in the next wash cycle. part of the door. 9.For appliances with type Y attachment,the 10.The installation instructions shall state intructions shall contain the substance of the that the appliance is to be connected to the following. water mains using new hose-sets and that If the supply cord is damaged,it must be the old should not be used. replaced by the manufacturer,its service For washing machines with ventilation agent or similarly qualifled persons in order openings in the base,that a carpet must not to avoid a hazard. obstruct the openings. Trouble-shooting The following problems are not always caused by faults, Before calling the Service Center, please check to see if the faults can be self-corrected. Problem Possible cause l l The washing machine does not start l l Poor connection to power supply Power failure Door is not properly closed (Err 1) The machine is not switched on . Washing machine cannot be filled with water l Water tap is not turned on l Water pressure is less than 0.05Mpa l The inlet hose is kinked l Water supply failure l The program knob is not properly set l The door is not properly closed The machine is draining while is l The height of the drainage hose is below 80cm (it being filled should be within 80-100cm) Drainage failure l Drainage hose is blocked l Drainage hose end is below 100cm above the floor level l The filter is blocked Strong vibration during spinning l Not all packing bolts have been removed l Washing machine is located on an uneven surface or is not level l Machine load is over 6kg. Operation stops before completion l Water or electricity failure of a wash cycle l Washing machine is in a soaking cycle l Washing machine gives an error message. Excessive foam in the drum, which l The detergent is not a low-foaming type is spilled to the distribution drawer l Excessive use of detergent