Haier LY22T1CBW User Manual - Page 10

Connection Instructions VGA Input You can use your LCD-TV as a monitor for your personal computer using a VGA cable (not supplied). Connection and use steps: 1.Read the user guide supplied with your computer and ensure that it has a VGA connector; 2.Make sure that the power of the LCD -TV and the PC are off; 3.Connect a D type 15-pin VGAinterface cable ( not supplied ) to the VGA video VGA IN interface connector on the PC. Then connect the other end to the PC video interface connector on the back of the LCD-TV.Tighten the screws on the VGA connectors once they are firmly connected, connect the audio cable(not supplied)to the audio input on the back of your LCD-TV; 4.Turn on the power of the LCD-TV first , and then turn on the power of the PC; 5.Set the video input mode of the LCD-TV to PC; 6.Check the image on your TV. There may be noise associated with the resolution, vertical pattern, contrast or brightness in PC mode. If noise is present, change the PC mode to another resolution, change the refresh rate to another rate or adjust the brightness and contrast on the menu until the picture is clear. If the refresh rate of the PC graphic card cannot be changed,change the PC graphic card or consult the manufacturer of the PC graphic card. Mode Resolution Line frequency (Khz) Frame frequency (Hz) VGA 640*480 31.5KHz 60Hz SVGA 800*600 37.9KHz 60Hz XGA 1024*768 48.4KHz Note: All above listed are subject to VESACriteria. 60Hz YPbPr Input How to connect Connect the DVD video outputs (Y, PB, PR) to the Component(Y, Pb, Pr) in socket on the TV and connect the DVD audio outputs to the AUDIO jacks on the TV, as shown in the figure. NOTE: If your DVD player does not have component video output, use S-Video. How to use 1. Turn on the DVD player, insert a DVD. 2. Set the mode of the LCD-TV to Component.