Harman Kardon AVR 110 Owners Manual - Page 20
Main Information Display
View all Harman Kardon AVR 110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
System Configuration To set the delay times, follow these steps: 1. Put the AVR 110 in the Dolby Pro Logic mode by pressing the Surround Mode Selector 7 on the front panel or by pressing the Surround Mode Selector j on the remote, until PRO LOGIC appears in the Main Information Display W and the PRO LOGIC indicator F lights up. 2. Press the Delay button 29 Ò on the remote or front panel. The words S DELAY TIME will appear in the Main Information Display W. 3. Press the Set button oÔ . 4. Adjust the delay time by pressing the ⁄/¤ buttons mq on the remote or the Selector buttons 5 on the front panel until the delay time figure calculated using the formula entered above appears in the display. 5. If only analog sources will be used, no adjustment is needed for the center-channel delay. In that case, press the Set button oÔ to enter the surround delay settings into the AVR 110's memory. However, if you will be using digital sources and the calculations outlined above indicate that the center-channel delay requires an adjustment, continue with the following steps. 6. Before setting the center-channel delay time, make certain that a digital source has been selected. If a digital source is playing, COAXIAL E or OPTICAL B will appear in the Information Display Û. If a digital source is already connected and playing, press the Delay button Ò 29 and then the ⁄/¤ buttons on the remote mq or the front panel Selector buttons 5 until the words C DELAY TIME appear in the Main Information Display Û and proceed to Step 10. If a digital source is not playing, follow Steps 7 through 10. 7. Press the Set button oÔ. 8. Select the Dolby Digital mode either by pressing the front panel Surround Mode Selector 7 or by pressing the Surround Mode Selector j on the remote on the remote until DOLBY DIG appears in the Main Information Display W. 9. Press the Delay button 29 Ò on the remote or front panel. The words S DELAY TIME appear in the Main Information Display W. 10. Press the ⁄/¤ buttons mq on the remote once, so that C DELAY TIME appears in the Main Information Display W. 11. Press the Set button oÔ. 12. Press the ⁄/¤ buttons mq on the remote or the Selector buttons 5 on the front panel until the desired delay time for the center channel appears in the display. 13. Press the Set button oÔ to enter the setting into the AVR 110's memory. You have now completed the setup, adjustment and calibration of the AVR 110. You are now ready to enjoy the finest in music and hometheater listening. 20 SYSTEM CONFIGURATION