Harman Kardon FESTIVAL 3 Owners Manual - Page 3
Installation
View all Harman Kardon FESTIVAL 3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Installation PREPARATION FOR USE OF RECORD CHANGER 1. Carefully remove the rubber band securing the stabilizer arm to the transit screw. 2. Turn both transit screws clockwise until they are all the way down against the main plate and the turntable is floating freely on its springs. 3. Remove the large piece of protective cardboard which stradles the turntable platter. 4. Remove the two pieces of semi-circular cardboard located underneath the edge of the turntable platter. 5. Unlock the stabilizer arm by pressing down at the top rear near the housing and rotate the front free end toward the center of the turntable. 6. Remove the piece of tape holding the tone arm to the tone arm rest. 7. Remove the piece of tape holding the stylus guard to the cartridge. 8. Remove the stylus guard. RECORD CHANGER ADJUSTMENTS The record changer has been accurately pre-adjusted at the factory. No adjustment should be necessary for quite some time. If ,it becomes evident that adjustment is necessary, complete instructions will be found in the SERVICE AND MAINTENANCE section of this manual. STYROFOAM PACK (2) PACKING CARDBOARD RUBBER BAND MAIN PLATE PACKING CARDBOARD ENVELOPE CONTAINS -_-_- 1 OWNERS MANUAL 2 SPEAKER CABLES 1 MANUAL SPINDLE 1 AUTOMATIC SPINDLE PROTECTIVE CARDBOARD (2) TRANSIT SCREW TURNTABLE PLATTER STABILIZER ARM HOUSING 4.411 TRANSIT SCREW TONE ARM TAPE STYLUS GUARD