Harman Kardon HK330I Owners Manual - Page 6

Components and Their Functions (Rear Panel) e FM ANTENNA TERMINALS (FM 300O BAL) (FM 75O UNBAL) These terminals are connected with feeders from the FM antenna (a 30052 parallel feeder cable, a 7552 coaxial cable or the accessory feeder antenna ). ) AM ANTENNA TERMINAL (AM) In a fringe reception area or inside a concrete building where the AM broadcasting signals are too weak for good reception, erect an AM outdoor antenna and connect this terminal to it. ®PHONO INPUT TERMINALS (PHONO INPUT) Connect these terminals with the output cords of the turntable (Use MM-type cartridges). ® AUX/DAD INPUT TERMINALS (AUX/DAD INPUT) Use these terminals when another program source (such as a television tuner or compact disc player) is desired. (TAPE INPUT TERMINALS (TAPE IN) Connect these terminals with the output terminals of the tape deck. e TAPE OUTPUT TERMINALS (TAPE OUT) Connect these terminals with the input terminals of tape deck. ott it) ®GROUND TERMINAL (GND) Connect this terminal to the ground wire of the turntable. / 4 AM FERRITE LOOPSTIC ANTENNA This antenna is used for AM reception. This high-sensitivity ferrite loopstic antenna re- quires no AM outdoor antenna except in a fringe reception area where signals are weak. Adjust the antenna back and forth and set is at the optimum reception. SPEAKER SYSTEM 1 CONNECTOR TERMINALS (SPEAKER SYSTEM 1) Connect these terminals to the speaker cords. Make certain that the left and the right channels are connected properly, and that the speaker polarities and not reversed. 6 rim OPOWER LINE CORD Connect this cord to the AC outlet. e AC CONVENIENCE OUTLET (SWITCHED) This outlet can be used for the turntable, tape deck or other components. The component plugged in this outlet is turned ON and OFF when this unit is turned ON and OFF. The maximum al lowable power is 180W. (4) SPEAKER SYSTEM 2 CONNECTOR TERMINALS (SPEAKER SYSTEM 2) These terminals are for the 2nd speaker system. Connect them in the same manner as speaker system 1.