Harman Kardon MAS 102 CD Player and Amplifier Owners Manual - Page 11

ENGLISH mas system Operation Using the mas system is simple and intuitive. The front-panel controls use advanced touch-sensitive technology. To use the front panel, place a finger over any of the illuminated icons. A gentle tap is all that is necessary. Wait a few seconds for the system to process each command. To remove fingerprints, wipe the front panel with a dry microfiber cloth. Using the Remote Control Point the remote at the front of the mas system. The remote IR sensor is located on the right half of the front panel of the controller. Do not block the sensor. The remote has a range of approximately 6m, up to 30 degrees off center. If the batteries require replacement, see Step 2 of the Installation section. Use caution and dispose of batteries according to environmental requirements. Never throw the batteries into fire, and remove them from the remote if the remote will be unused for a long period of time. Turning On the mas system To turn on the MAS 101/MAS 102/MAS 111, press and hold the Power Button on the remote or the controller for 1 second. The system will also turn on when one of the Source Selectors or the Eject Button on the remote is pressed. Press the Power Button to turn off the system. If the clock has been turned off, the Message Display will go dark to conserve power. Otherwise, the time will be displayed at half-brightness. Setting the Clock The clock may be set using the Settings Menu. See Figure 2. 1. Press the Settings Button on the remote. 2. Press the M/N Buttons until "Time Setup" appears in the Message Display. 3. Press the Enter Button to display "Clock". Turn the clock on or off: Press the Enter Button and use the M/N Buttons to select "On" or "Off". Turning the clock off conserves power when the system is powered down to Standby mode. 4. Set the clock: Press the M/N Buttons until"Set Clock"appears on the lower line. Press the Enter Button to display "Set Time". • Set the time: Press the Enter Button and use the Numeric Keys to enter the hour, then the minute. If the 12-hour time format is active, use the M/N Buttons to select "AM" or "PM". Press the Enter Button to advance from one field to the next without changing it, and press the Enter Button to save the settings. • Set the format: Press the M/N Buttons until "Set 12/24 hour" appears. Press the Enter Button to change the format, and use the M/N Buttons to select between the 12- and 24-hour time displays. Press the Enter Button to save the change. 5. Set the day of the week: Press the M/N Buttons until "Set Day" appears. Press the Enter Button to display the day of the week, and use the M/N Buttons to select the desired day. Press the Enter Button to save the changes. Figure 2: Setting the Clock Settings Speaker Setup > Right Left Time Setup Clock > Right Left Enter Enter or Back Clock Off > Settings < Time Setup > Enter Back Time Setup Set Clock > Enter Back Right Left Time Setup < Set Day Enter Enter or Back Set Day Monday > Set Clock Set Time > Right Left Enter Enter or Back Set Time 12 : 43 > Set Clock < Set 12/24 hour > Enter Enter or Back Set 12/24 hour 12 hour > 11