HealthRider H500 Treadmill English Manual - Page 8
Damaged When The Power Is Turned On.
View all HealthRider H500 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. See drawing 5c. With the help of a second person, hold the Console Base (101) near the Uprights (97). Look under the Console Base and locate the wires on the sides of the Console Base. Make sure that the wires are not routed through the openings for the Trays (111, 112). Drawing 5a shows the correct route for the wires. Drawing 5b shows an incorrect route. See drawing 5c. Cut the plastic ties holding the Wire Harness (74) and the pulse wire in the Uprights (97). Connect the Wire Harness and the pulse wire to the connectors on the sides of the Console Base (101). Make sure to connect the connectors properly (see the inset drawings). IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn a connector and then try to connect it. Insert the excess Wire Harness and pulse wire up into the Console Base. 5a Correct 5c 111 74 97 74 5b Incorrect 101 112 97 Pulse Wire 6. Set the Console Base (101) on the Uprights (97). Thread 6 the four Console Bolts (89) with four Internal Star Washers (113) into the Uprights and the Console Base. Be careful not to pinch the Wires (not shown) in the Uprights. Tighten the two Console Bolts indicated by the arrows first; then, tighten the remaining two Console Bolts. Make sure that the Right and Left Trays (111, 112) are pressed into the Console Base (101). 89 111 113 97 101 97 112 113 89 113 89 7. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 27). To protect the floor or carpet, place a mat under the treadmill. If there are thin sheets of clear plastic on the decals on the treadmill, remove the plastic. 8