HealthRider Pro H250i Treadmill Chen Manual - Page 6

2 1/2" Bolt (37)-2 ASSEMBLY 3 1/2" Bolt (45)-4 Wheel Nut (32)-2 Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill HwaanlkdinragilbBeoltltis(64)-4 coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Star WashAesr sembly requires the included hex key and your own Phillips screwdriverExtension Leg. Bolt (96)-4 (84)-2 Use the drawiEnxgtsenbseiloonwLteogidBeonltif(y96th)e-4hardware usWedhdeuerliNnguta(s1s3e)m-2bly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly. 3/4" Tek Screw (72)-2 3/4" Screw (23)-10 1" Tek Screw (77)-6 Cover Screw (52)-4 Pulse Bar Star 3/8" Star Washer (65)-4 Washer (83)-4 Endcap Screw (108)-2 Pulse Bar Screw (64)-4 Console Screw (67)-4 2 3/4" Upright Bolt (85)-2 1" Upright Bolt (84)-2 1 1/4" Bolt (63)-4 1. Make sure that the power cord is unplugged. 1 With the help of a second person, carefully tip the treadmill onto its left side as shown. Partially fold the Frame (26) so the treadmill is more stable. Do not fully fold the Frame until the treadmill is completely assembled. Identify the Right Upright (76), which has a sticker attached to it. Hold the Right Upright in the position shown. Next, locate the long wire in the lower end of the Right Upright (see the inset drawing). Securely tie the long wire to the Upright Wire (75). Then, pull the opposite end of the long wire until the Wire Harness is extending from the upper end of the Right Upright. Make sure that the Upright Wire is on the indicated side of the Right Upright. Finger tighten a 2 3/4" Upright Bolt (85) and a 1" Upright Bolt (84) with two 3/8" Star Washers (83) into the bottom of the Right Upright (76). Do not tighten the Upright Bolts yet. 6 75 76 26 Wire 75 85 83 84