HealthRider Pro H250i Treadmill Chen Manual - Page 9

8. Orient the Pulse Bar (66) as shown. Attach the 8 Pulse Bar to the Left and Right Uprights (70, 76) 64 with four Pulse Bar Screws (64) and four Pulse Bar Star Washers (65). Firmly tighten the 65 Pulse Bar Screws. 66 70 64 65 9. While a second person holds the console assembly near the Pulse Bar (66), connect the Ground Wire (107) on the Pulse Bar to the ground wire on the console assembly. Next, connect the indicated wire on the console assembly to the Upright Wire (75). Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. If they do not, turn one connector and then try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the connectors downward into the Right Upright (76). 9 Ground Wire 107 66 76 Console Assembly 75 Wire 75 76 10. Set the console assembly on the Left and Right Uprights (70, 76). Be careful not to pinch any 10 wires. Attach the console assembly to the Pulse Bar (66) with six 3/4" Screws (23). Do not tighten the Screws yet. Console Assembly 66 23 23 76 23 70 9