HP 10/100 3Com 3c905C-TX HP 3COM LAN cards (D7522A, D7523A), User Guide - Page 21

HP 10/100 3Com 3C905C-TX Network Interface Card Installation Guide HP Support Services The PC Cannot Be Started or Woken-Up from the Network 1 Refer to "Remote Wake-Up and Remote Power-On Support" on page 4 to check that your combination of power management solution and operating system is supported. 2 If the PC has been powered off (for example, due to an electrical power failure, or because the power cord has been removed), the Remote Power On (RPO) will not work. To enable the RPO, you must first power on the PC, allow the Operating System to boot, then shut down the PC. 3 Check that the WOL connector cable is connected to the network interface card and to the PC's system board. 4 Check that the LAN-specific fields in the HP PC Setup utility are correctly set (refer to "Updating LAN-specific Fields in the HP PC Setup Utility" on page 10.) HP Support Services The latest drivers and utilities are available on HP's Web site at: For HP Vectra PCs For HP Brio PCs For HP Kayak PC Workstations www.hp.com/go/vectrasupport www.hp.com/go/briosupport www.hp.com/go/kayaksupport English 21