HP 200 HP StorageWorks XP Disk Array Configuration Guide for Linux XP24000, XP - Page 15

Configuring the Fibre Channel ports, View XP arrays only

Page 15 highlights

The following host group mode (option) is available for : Table 2 Host group mode (option) Host Group Mode 7 Function Default Reporting Unit Attention when adding LUN Inactive Comments Previously MODE249 CAUTION: Changing host group modes for ports where servers are already installed and configured is disruptive and requires the server to be rebooted. Configuring the Fibre Channel ports Configure the disk array Fibre Channel ports by using XP Remote Web Console (shown), XP Command View (XP arrays only), or XP Command View Advanced Edition Software. Select the settings for each port based on your storage area network topology. Use switch zoning if you connect different types of hosts to the array through the same switch. XP Disk Array Configuration Guide for Linux 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

The following host group mode (option) is available for :
Table 2 Host group mode (option)
Comments
Default
Function
Host
Group
Mode
Previously MODE249
Inactive
Reporting Unit Attention when adding LUN
7
CAUTION:
Changing host group modes for ports where servers are already installed and configured is disruptive and
requires the server to be rebooted.
Configuring the Fibre Channel ports
Configure the disk array Fibre Channel ports by using XP Remote Web Console (shown), XP Command
View (XP arrays only), or XP Command View Advanced Edition Software. Select the settings for each
port based on your storage area network topology. Use switch zoning if you connect different types
of hosts to the array through the same switch.
XP Disk Array Configuration Guide for Linux
15