HP 625n HP Jetdirect Administrator's Guide - Page 206
Table 9.1, HP Jetdirect Configuration 2 of 2
UPC - 882780301252
View all HP 625n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 206 highlights
Table 9.1 HP Jetdirect Configuration (2 of 2) Message Description PORT SELECT: (Ethernet only) Specifies the port on the HP Jetdirect print server that has been detected for use: NONE: The print server is not connected to the network. RJ-45: The RJ-45 network port is connected. LAA The Locally Administered Address (LAA) identifies the user-specified LAN hardware address of a print server, which may be required by some network adiministrators. The default address is the print server's factory-default LAN hardware address. PORT CONFIG: Identifies the link configuration of the RJ-45 port on the HP Jetdirect 10/100Base-TX print server: 10BASE-T HALF: 10 Mbps, half-duplex 10BASE-T FULL: 10 Mbps, full-duplex 100TX HALF: 100Mbps, half-duplex 100TX-FULL: 100Mbps, full-duplex UNKNOWN: The print server is in an initialization state. DISCONNECTED: A network connection has not been detected. Check network cables. AUTONEGOTIATION Identifies whether IEEE 802.3u Autonegotiation on the HP Jetdirect 10/100TX port is enabled (ON) or disabled (OFF). ON (default): The HP Jetdirect print server will attempt to automatically configure itself onto the network at the proper speed (10 or 100 Mbps) and mode (half or full duplex). Autonegotiation is enabled after a cold reset. OFF: You must manually configure the speed and mode using the EIO menu from the printer's control panel. If Autonegotiation is off, the settings must match those of the network for proper operation. MANUFACTURING ID: The manufacturing identification code for use by HP online support personnel. DATE MANUFACTURED: Identifies the date of manufacture of the HP Jetdirect print server. ENWW HP Jetdirect Configuration Page 206