HP 6400/8400 HP StorageWorks 6400/8400 Enterprise Virtual Array expansion rack - Page 15
Attach the rails, Square hole to round hole cabinet conversion
View all HP 6400/8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
2. Use a No. 2 Phillips screwdriver to remove the standard pins from the front and back of the left and right rails (four pins on each rail). Figure 6 Square hole to round hole cabinet conversion . 3. Insert the round-hole pins into the eight holes on the rails where the standard pins were removed. Attach the rails NOTE: The left and right rails are designated by the letters R (right) and L (left) stamped into the metal on the front of the rack. Consider the following when installing the rails: • Installing the rails does not require any tools for assembly. • HP recommends you install all the rail kits before installing any other components. • Ensure the rails are level before installing any other components. WARNING! Before you begin, ensure that the rack is sufficiently stable. If provided, lower the rack leveler feet and make sure any required stabilizers are installed. If provided, extend the anti-tip device. Failure to extend the anti-tip device could cause personal injury or damage if the rack tips over. HP StorageWorks 6400/8400 Enterprise Virtual Array expansion rack reference guide 15