HP 750c HP DesignJet 700 user guide - Page 194
Sheet / Roll?
View all HP 750c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
Front-Panel Messages Message Service cartridge(s) Continue ! Explanation and Action Cartridge Check is on and an error has been detected. Press ↑ if you want to service the cartridge(s) (replace or reseat). Press ↓ if you want to continue without servicing the cartridge(s). Sheet load Roll load ! Press ↑ to load sheet media. ! Press ↓ to load roll media. Sheet misaligned Reload sheet Sheet media is misaligned (skewed). Remove it and reload it so that the left and right edges being loaded into the plotter are square. The leading edge must also be straight. Sheet / Roll? Reload media D Either: You have chosen Sheet mode while loading roll media. Reload media. D Or: You have loaded a sheet more than 51 inches (130 cm) long. Trim sheet and reload. STATUS Accessing cartridge(s) You have pressed the Access cartridge(s) button. The cartridge carriage is moving to the service cartridge(s) position so you can access it. STATUS The plotter is aligning the cartridge(s). Aligning cartridge(s) STATUS Cancelling You have pressed the Cancel button and the plotter is in the process of cancelling the procedure. Continue when this message is no longer displayed. STATUS Checking media The plotter is checking to see if media is properly positioned with respect to the perforated line of the entry platen. STATUS Calibrating The plotter is performing calibration. STATUS The ink on your plot is drying. Wait before removing the plot. If you remove it Ink drying (xx m xx s) before the indicated time has passed, avoid smearing the ink. STATUS Loading roll The plotter is loading roll media. STATUS Loading sheet The plotter is loading sheet media. STATUS Maintenance advised You are using the plotter more intensively than the recommended duty cycle and should contact your local HP dealer or HP service engineer to arrange a service. For the duty cycle specification, see page 11-4. If you choose to not to call for service, you may continue to use the plotter as normal, but may encounter operational or print-quality problems. STATUS Measuring The plotter is measuring the calibration plot you just loaded. 10-4