HP 8/80 Fabric OS Administrator's Guide v6.4.0 (53-1001763-01, June 2010) - Page 221
In Virtual Fabric-enabled mode, the, TABLE 42
View all HP 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 221 highlights
Configuration file restoration 8 -all The number of switches or FIDs defined in the downloaded configuration file must match the number of switches or FIDs currently defined on the switch. The switches must be disabled, if necessary (refer to "Configuration download without disabling a switch" on page 182 for more information on non-disruptive configuration downloads). If they are not, the configDownload command downloads the configuration for as many switches as possible until a non-disabled switch is encountered. Then it will stop. Before running this command, verify if any switches need to be disabled. If you are performing a configDownload due to a configuration error, it is highly recommended to perform a configDefault before running the configDownload command. In Virtual Fabric-enabled mode, the chassisDisable and chassisEnable commands are used to disable all logical switches on the affected switch. This bypasses the need to disable and enable each switch individually once the configuration download has completed. Non-Virtual Fabric configuration files downloaded to a Virtual Fabric system will only have configuration applied to the default switch. If there are multiple logical switches created in a Virtual Fabric-enabled system, there could be some issues if there are ports that belong to the default switch in a Virtual Fabric-disabled system, but are now assigned to logical switches in a Virtual Fabric-enabled system. Only configurations related to ports within the default switch will be applied. In case something happens to your switch and you need to set it up again, run the commands listed in Table 42 and save the output in a file format. Store the files in a safe place for emergency reference. TABLE 42 CLI commands to display or modify switch configuration information Command Displays configShow fcLunQuery fcrRouterPortCost fcrXlateConfig fosConfig ipAddrShow iscsiCfg iscsiPortCfg iscsiTargetName isnscCfg licenseShow portCfgEXPort portCfgVEXPort System configuration parameters and settings, and license information. A list of LUN IDs and LUNs for all accessible targets. FC Router route information. A translate (xlate) domain's domain ID for both EX_Port-attached fabric and backbone fabric. Fabric OS features. The IP address. iSCSI entities. The iSCSI port parameters. The IQN prefix. The configuration state of the iSNS client operation. The license keys you have installed and provides better detail than the license information from the configShow command. EX_Port configuration parameters. VEX_Port configuration parameters. Fabric OS Administrator's Guide 181 53-1001763-01