HP 8/80 Fabric OS Administrator's Guide v6.4.0 (53-1001763-01, June 2010) - Page 57
Telnet or SSH sessions, Rules for Telnet connections, Connecting to Fabric OS using Telnet
View all HP 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Fabric OS command line interface 2 • In a UNIX environment, enter the following string at the prompt: tip /dev/ttyb -9600 If ttyb is already in use, use ttya instead and enter the following string at the prompt: tip /dev/ttya -9600 Telnet or SSH sessions Connect to the Fabric OS through a Telnet or SSH connection or through a console session on the serial port. The switch must also be physically connected to the network. If the switch network interface is not configured or the switch has been disconnected from the network, use a console session on the serial port as described in "Console sessions using the serial port" on page 16. NOTE To automatically configure the network interface on a DHCP-enabled switch, plug the switch into the network and power it on. The DHCP client automatically gets the IP and gateway addresses from the DHCP server. The DHCP server must be on the same subnet as the switch. See "DHCP activation" on page 23 for more details. Rules for Telnet connections The following rules should be observed when making Telnet connections to your switch: • Never change the IP address of the switch while two Telnet sessions are active; if you do, your next attempt to log in fails. To recover, gain access to the switch by one of these methods: - You can use Web Tools to perform a fast boot. When the switch comes up, the Telnet quota is cleared. (For instructions on performing a fast boot with Web Tools, see the Web Tools Administrator's Guide.) - If you have the required privileges, you can connect through the serial port, log in as admin, and use the killTelnet command to identify and kill the Telnet processes without disrupting the fabric. • For accounts with an admin role, Fabric OS limits the number of simultaneous Telnet sessions per switch to two. For more details on session limits, refer to "Managing User Accounts" on page 83. Connecting to Fabric OS using Telnet 1. Connect through a serial port to the switch that is appropriate for your fabric: • If Virtual Fabrics is enabled, then log in using an admin account assigned the chassis-role permission. • If Virtual Fabrics is not enabled, then log in using an account assigned to the admin role. 2. Verify the switch's network interface is configured and that it is connected to the IP network through the RJ-45 Ethernet port. Switches in the fabric that are not connected through the Ethernet port can be managed through switches that are using IP over Fibre Channel. The embedded port must have an assigned IP address. 3. Log off the switch's serial port. Fabric OS Administrator's Guide 17 53-1001763-01