HP 9040mfp HP LaserJet 9040mfp/9050mfp - Software Technical Reference (externa - Page 176
Font Substitution Table, PostScript Configurations, Available PostScript Memory, Output Protocol
UPC - 829160403649
View all HP 9040mfp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
setting. For example, for the HP LaserJet 9040/9050mfp, trays 1 and 4 are listed in both the Form to Tray Assignment setting and the Installable Options setting. The input trays listed here are also listed as media sources on the Page Setup tab. Font Substitution Table Clicking this option opens the font substitution table and makes available the options for changing the TrueType-to-PostScript font mapping. PostScript Configurations The following controls are available and appear in the PS Emulation Driver. Available PostScript Memory This control specifies the amount of available postscript memory and provides a spin box for changing this value. The available postscript memory is a subset of the product total physical memory. It is usually best to set the postscript memory to match what is shown on the configuration page. To print a configuration page from the control panel, press the Select button (the one with the check mark) to open the menus. Next, press the up and down buttons to scroll to INFORMATION, and then press the SELECT button. Next, press the up and down buttons to scroll to PRINT CONFIGURATION, and then press the SELECT button. Output Protocol This control specifies the protocol that the product uses for print jobs. The following options are available: ■ ASCII (default) ■ TBCP ■ Binary When you click ASCII, data is sent in ASCII format (7-bit), which might take longer to print but can be sent through any I/O channel, such as a serial, parallel, or network port. When you click TBCP (Tagged Binary Communications Protocol), all data except special control characters is sent in binary (8-bit) format. The binary formats can be sent over parallel or serial communications ports and are faster than sending data in ASCII format. When you click Binary, all data except special control characters is sent in binary (8-bit) format. The binary formats can be sent over parallel or serial communications ports and are faster than sending data in ASCII format. Send Ctrl-D Before Each Job This control specifies whether the product will be reset at the beginning of every postscript document. The default setting is No. Ctrl-D resets the product to its default setting to ensure that previous print jobs do not affect the current print job. Ctrl-D might cause a print job to fail if the product is connected through a network. If your document fails to print when sent to a product connected through parallel or serial ports, change No to Yes. 160 3 HP traditional print drivers for Windows